I think the maximum recommended retraction is 1.5mm @35mm/sec with the NG. Likely due to being such a short path, even compared to their old one :). Thanks for the great video. Really good information and great install tutorial
I run this now for 3 plus months now in a up to 90C chamber with a 45C head blower no better fix into an industrial replacement for me with the HT heater block and a bondtech CHT with a pt1000 and 3:1 drive whats more to say
Put mine on an Ender 3 Max and switched to Klipper and Fluidd. I had to recalculate the 400 eStep value to suit Klipper's Rotation_distance value.....but seems to be working great!!
steps per mm does not show up, so I have different board driver. f my life. I have cr touch and now I don't have a print of the adapter either. What a ffing fail.
Really disappointed in microswiss on this one. No instructions included and I must have missed the point in people's videos talking about the extension cable and it's too switched wires. But come on who relies on community videos for their instructions. What you can R&D apart but you can't pay someone to write a paragraph? My printer does not extrude at all anymore I'm hoping that this garbage setup just blew a stepper driver and nothing else. Even a small card with a warning would have been nice. I thought it was just an extension to go from Bowden to direct drive.
