I have the exact Hamilton Beach 900w same as yours. I watched the video and decided I would just get a new one rather than trying to fix this one. I said if its going to recycling anyway, why not just try to unstick the switch with a good hard door slam. If it breaks, so what its going anyways. So I did, gave the door a good slam. It didn't break, and it unstuck the switch. That was a few days ago. Working as good as new again.
Hmmm. I’m not sure. It might be time for a new one. Sorry about that. I have heard that there is a breaker switch but I just worry about disconnecting that.
I sort of have this problem When I close the microwave door the microwave turns on by itself but since I don't know how to repair the microwave I opened the door then close it again and press a minute and let it run for a few seconds then I open the door again then the microwave turns off
Thank you for this. However, our unit is a combination microwave convection oven. The unit has 3 switches but they are very obscured by lot of wire. What was difficult was the removal of the switches, as there were clips and pins. We used a hair dryer to soften the clip material which helped. Also I suggest looking the way the door clicks the switch buttons. That way you can determine which of the three is faulty. (I hadn’t noticed that the top switch was faulty and took the middle one out first. Not a good experience, as a pin broke. Make sure you look first, take pictures, uses a hair blower and be patient.) Mine also was an overhead placement which was awkward to remove.
@@TryThisDIYFix There was another post that approached the similar problem by taking out the control panel and then unscrewing the complete switch unit. He accessed the clip holders from behind to release the switches. This access approach is not always appropriate because in mine, the screws holding that bracket were only accessible on the inside once you took the housing off. Again, thank you for opening the picture on this initial problem. Much appreciated.
@@TryThisDIYFix yep just like new. I guess the latch or whatever was stuck. Good ol fashion irritated slam, plugged it back in & it didn't go on when I opened the door. Saved me $75.
I have Panasonic the genius sensor 1350w does not have those grey things you mentioned? What am I looking at? I have the same trouble turn table moving all the time even when I’m not using
Great video! I followed your instructions and found 1 bad switch. Then I replaced it but it is running when door opens. I guess it is time for new one.
I have that same problem on my West Bend 900 W microwave. The plate rotates when I open the door, but the magnetron does not come on. There’s no radiation, especially since I measured it with my high frequency analyzer. But if the magnetron comes on, close the door immediately!
EFF YEAH I JUST FIXED MY DEMON MACHINE! it was quick, the primary top switch wasn't even burnt out, just slightly misaligned... probably from years of uhhh slamming the door, lol. this video saved me a benjamin, so thank you!
I think there are. I don’t think it’s safe for it to be running while it’s open. It’s a pretty easy fix, let me know if you are able to try it. Thanks for watching!
Look people just buy another microwave it's not that serious. Taking it apart and doing this shit is not worth it ok due to microwaves are cheap now a days