@@eltiburonsangriento Hi, I did a sensor test on the service menu and it said that microswitch #4 was closed, so I am going to try to take off the mount and replace the microswitch #4, If that doesn't work I will buy a brew unit, i will report back. thanks!
@@sprinter4489 If you take it apart make sure to do it very slowly because there are springs It very rarely go bad is not making because the mechanism on the brew unit is broken and it doesn’t reach it when it gets ready to brew. Good luck good luck
Thanks to your video I was able to get my Miele CVA4075 back onto the gear, but I keep getting fault73. I believe it has to do with the 2 sensors, not the brew unit itself, because it opens up with that fault73. I found on line the technical guide which stated that if the sensors don't connect with the brew unit within in 10 seconds of operation that means the sensors are not making contact, or the w is not moving up and down with the brew unit itself . Can the diagnostics of the machine tell which item is not working, the brew unit, or the microswitches (sensors) on the brew unit drive which I would have to disassemble from the back. Thanks.
Great info, thanks! I have a problem with my CVA 4075 - when brewing, the coffee doesn't dispense from the dispenser, it only drips out and flows out of the two holes at the top of the adjustable dispenser (behind the removable Miele faceplate). I used a pipe cleaner to remove the grounds from the spouts and it seems pretty clear. I have cleaned, descaled and degreased the unit. Any ideas as to what's causing it and how to fix it?
It could be that you have your grinding settings to too fine. Causing fine grinds to go through the percolator in grind unit. Set it to normal it should improve. It could also be the type of coffee you’re using. Make sure Beens are not shiny , they tend to get too sticky.
If I put ground coffee it works if I put beans I get water. I cleaned it with a vacum to the best I can and the grinder sounds fine but it makes a weird noise after grinding like something blocked. I’ve descaled and cleaned but still the same problem. Any ideas
Hello and thank you for watching. I am not familiar with that model yet but if you take a snap picture of a model number and posted I’ll be able to see look for tech layout. And then maybe come up with a solution I am thinking that the milk line is plug with harden milk or the pump itself is not working. May also want to look in the owners manual, and do a cleaning