After installing the new monport lightburn board we had an alignment issue with the laser and wanted to get a milliamp meter setup so that we could see exactly what the laser power settings are showing. Was able to get these both setup and ready to get back at it.
Don't forget to use our discount code!!!!
Use KLRform when placing an order for 6% off.
Monport 40W CO2
Laser - bit.ly/3r5yDbo
Used in this Video:
Milliamp Meter - amzn.to/3er1hjq
Control Keyboard - amzn.to/3SQiqCR
Wirecutter - amzn.to/3RzdrFg
Wire Cripmers - amzn.to/3cRJOAn
14 Gauge Wire - amzn.to/3TOCXIv
Wire Connector kit - amzn.to/3cRm3Zg
Exhaust System:
Duct Fan - amzn.to/3uXOCJ8
Vent - amzn.to/3DoWDd5
Duct - amzn.to/3iMujt4
Air Assist Pump - amzn.to/3Bw4qoM
Other Laser Equipment:
Laser - amzn.to/30d66G8
Upgraded Version - amzn.to/3FptVum
Laser Rotary - amzn.to/3uVWfQh
Atomstackofficial - bit.ly/3Clhr62
P9 M40 Portable Laser Engraver - bit.ly/3HPKpw0
Our 3D Printer:
Ender 3 pro - amzn.to/3j3y5hs
PLA 3D Filament - amzn.to/3LF47N3
Hex Driver - amzn.to/3E3Ltfk
5 сен 2024