Mirrors with the doors off! Must Have Jeep Wrangler TJ Doors Off Mirrors! 

Thanks 👍

Thanks Mike!

Thanks Brian for watching! Thanks for taking the time to comment also. Means a lot to the channel!

Did you like them? Thinking of ordering

I want to go! Have fun Pete!

Good to know. Do you have a link?

@@ForceBuilt no I just pulled an old mirror out of my junk pile and stuck it in the door hinge hole

Yeah Ed, they seem to work great and I like the way they look! Thanks for stopping by!

Awesome Mark! When this pollen dies down a little, I will be going without mine also. Mine is a daily driver so they go back on for rainy days.

Thanks Luis!

@@ForceBuilt Finally bought these. Had the others that would stay on the door hinge. Wanted something easier. Let's see how these do. Cool jeep and color by the way!

@@Ro3Go Hey, thanks! Hope you like them!

@@Ro3Go did you like them? Thinking of ordering

@@johncena2336 Bought them and like them! Easy to install and no shaking.

They only fit on the side like you see here. Thanks for watching!

I haven't had that issue. I do remember having to get them very tight with the hand screw the first time. You may have to tighten it real tight the first time to make sure the mounting surface is seated fully against the mirror. After everything is mated real good it should work better. The ears of the mounting surface may be just a little too wide and need to be bent in a little . That is why I say to get it real tight the first couple of usages. Hope this helps and thanks for asking!

As you can see in the video, mine weren't tight at all. I recently disassembled the entire Jeep and painted it. I don't remember how tight they were then either. Thanks for the compliment! I have put a lot of work into my Jeep. Did you ever get the bolt out?

@@ForceBuilt No, my stripped bolt is a future project. I had the same issue taking off my front bumper, but since they weren't near paint I could use a torch to heat them up and get them out that way.

@@gregcollier472 yeah, I understand. I did have that trouble with my front and rear bumpers. I torched them real good! Good luck Greg!

Yes they do. Thanks Williams

Hi Kevin. I didn't have a problem with mine moving. They are very solid. I did tighten the bolt that holds them in position pretty tight though. It tightening the bolt more doesn't fix the issue, you may have a defect. Hope you get it worked out! Thanks

@@ForceBuilt I ordered similar-looking mirrors and put them on last night. The bolt doesn't keep them from moving despite the fact it's as right as it can be.

@@kevinbrinkley374 I would send them back and try a different set. If you need to keep them, get some skate board tape(Sticky sandpaper) and put it in between the pinch point. That should do it. Hope this helps!

@@ForceBuilt I actually stuffed in a washer on either side of the mirror holder. Gonna see if that holds. It's a bit sturdier, but I'm not sure how it will hold up at 40mph+