MoJack EZ Instructional Video 

My used MoJack cost me $50 on craigslist it is in decent condition, used it to change mower blades worked fine until i lowered it bound up why ? It pays to read the tag on the safety pin when the pins Pulled out the jack goes Down operator error not MoJack's - Good addition for working on a mower

ATTENTION: You may get a "safety updated" model whereby the tower locking pin (DOES NOT) lock when pulled and rotated. You must pull the pin (MANUALLY) as you crank the lift down. Each time you come to a lower locking pin hole, you must pull the pin out to get by the hole. Do that until you have reached the very bottom. When cranking back up again, you don't need to pull the pin, as it will ride by each hole. There are three holes. Choose the hole, or height you want, crack just above it, then crank back down. As you crank down, the locking pin should automatically spring into that hole to keep the tower from going lower. Hope that helps someone.

That’s nice but I’m an old geezer that basically needs the mower standing close to straight up. I’m not good at getting on the ground to remove blades…but I do it ‘cause that’s my only option. I have a manual Jack that works very similarly to this one except I have to push the handle down to lift the mower. Can’t do that forever. 😳

Excellent video!

This was when the Mojack was made in the US. The current version, made in China, is not as good and doesn't have the same safety precautions. Beware!

Would love to see a light weight car version of this. I drive a gen 1 honda insight. The whole car is only 2000lbs.

very easy to assemble - just take your time, don't overtighten the nuts. and my mower outside wheel measurement is only about 33" and it fits. I don't know where the 35.5" measurement comes from.

I have one and cannot get it to come down. I have to use pliers to turn the screw to get it to come down

Thank you, thank you!!

it's not very 'EZ' setup if you have to disassemble part of it before you can lower / raise it for storage !??