MOOER US GOLD 100

Подписаться 41 тыс.

Просмотров 6 тыс.

50% 1

Badass Friedman BE-100 sound in a preamp pedal that fits into your pocket. RAWK!
Timecodes:
- Intro: 0:00
- The Song: 0:11
- Overview: 1:33
- Overdrive channel with SD-1: 2:22
- Overdrive channel without SD-1: 3:13
- Clean channel: 4:14
- Conclusion: 4:50
The gear used & the signal chain:
- ESP E-II ECLIPSE EVERTUNE: bit.ly/2IHwvQ8
- MOOER US GOLD 100 Micro preamp 012: bit.ly/2U7iYXM
- BOSS SD-1 SUPER OVERDRIVE: bit.ly/39IoXbZ
- Avid Eleven Rack - as an audio interface
- Logic Pro X
Musamaailma: www.musamaailma.fi/
You can follow me also on:
/ eugeofficial
/ euge230v
/ euge230v
cyhra.com/
Check out our new album 'No Halos In Hell': media.nuclearblast.de/shoplan...
#EugeValovirta #Mooer #USGold

Видеоклипы

Опубликовано:

5 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 27

@ernestobenschop6087 4 года назад

Its sounds amazing!!!!

@EugeValovirta230V 4 года назад

Yeah! \m/

@ConradMH 4 года назад

Its sounds amazing my friend!!!!

@EugeValovirta230V 4 года назад

Thanks Conrad!

@zandig666 Год назад

Thx euge I'm checking these out !!!!!!👌✌️✌️🤟🤟💪💪

@EugeValovirta230V Год назад

🤟

@ayeapprove 2 года назад

I still think this is the best one for heavy tones, followed by the Fifty Fifty.

@joshuaphillips5379 2 года назад

Try the Blacklight 009. It's based on Engl . I like it better than the Fifty Fifty for heavy tones. Better mids.

@orcunozcan 3 года назад

What the hell!!🤘🤘

@EugeValovirta230V 3 года назад

🤘😎

@bjarkefredskildpedersen866 2 месяца назад

Hi. Hope you dont mind me reviving your old video. But, do you have a volume drop when you use the footswitch to switch from clean to dirty channel? I do, and I it makes it hard to use the pedal live, which is really annoying, because the pedal sounds great otherwise... Cheers

@tobiasschroter2862 3 месяца назад

Euge, would it be possible to use the mooer with the build in Box Simulation then Put a wampler DB boost after it (as a solo Volume boost) and the going straight into the pa/foh/Mixer? Greets from Germany ❤ Tobias

@EugeValovirta230V 3 месяца назад

Probably. I guess the only way to figure it out is to try it 😎.

@m.r.4455 3 года назад

Hi Is your setting the one I see on the top left of the screen? Your tone is very good, while I get a little muffle/ muddy

@EugeValovirta230V 3 года назад

Yes. Maybe you have a different guitar / pickups etc.? And do you have SD-1 in front too?

@m.r.4455 3 года назад

@@EugeValovirta230V thnx for your reply..! I’ve tried with a sg with a alnico PU, a Flying V with ceramic and a Ltd with fishman (active voicing). No od used. Yes it change but the overall impression is the same for all those setup. I tend to roll down the mids, while you keep them open...! Maybe my monitors aren’t fine (Yamaha Hs -5) but I expected a different voicing from this preamp. Your vid was the reason I bought this unit! You sound fantastic

@EugeValovirta230V 3 года назад

Mids are the key to a full bodied sound. More is more 👌.

@m.r.4455 3 года назад

@@EugeValovirta230V I will try to build the eq starting with more mids. I had just few minutes to try the preamp, it has arrived to me just today 👍🏻👍🏻😊

@EugeValovirta230V 3 года назад

👌🤘

@mattbelloni 3 года назад

Where it goes in the signal chain?

@EugeValovirta230V 3 года назад

Think of it like ’a preamp / amp in a box’. Hopefully this helps👌.

@mattbelloni 3 года назад

@@EugeValovirta230V so, at the end right? Thanks

@EugeValovirta230V 3 года назад

Yeah but you could put also dly, rev, cho after it so theyd be kinda in the effect loop. Just try different combinations and what sounds the best to you go with that. There’s no right or wrong way to do these things. If it sounds it’s good 👌😎.

@mattbelloni 3 года назад

@@EugeValovirta230V no problem, I don't use delay/rev/ echo :D

@EugeValovirta230V 3 года назад

😊👌