There's a mistake in this video made over and over and over again. It is the comparison between "transistor and MOSFET". Field Effect Transistor (FET, the FET in MOSFET), indeed ARE transistors! In fact, the 'T' in MOSFET stands for "transistor". A proper comparison would be made between Bipolar Junction Transistors (BJT) and Metal Oxide Semiconductor Field Effect Transistor (MOSFET) and those comparisons would be valid. The current presentation will just perpetuate confusion among newbies.
I sub to a lot of channels for entertainment. Videos like this I just find by searching as needed. But this was so well done, I can't help but sub. Really nice!
the video is educational, but yet getting a dislike due to generated voice instead of a normal human. the generated voice is monotone and sounds like from advertising.
so what about bldc gimbal like motors? do you know any controllers for them, I mean ready boards I can connect to the arduino and the motor and program? thanks for the video
I have a model train where in the power supply (0-12 VDC) is given through rail tracks. Which motor driver can I use to run the train in this case? Is it safe for the train engine (locomotive) motor if the supply is given this way? Thanks in advance.
I connect the the l298n to a stepper motor nema17 my DC power supply shows no current being drawn when I send a signal to move the stepper one revolution and then stops I notice it's still continuously drawing max amps and it's in CC mode an till I reset the Arduino then it goes back to normal again it's like the pins 8,9,10,11 are causing it to still run some how also after about 30mins the rc522 RFID scanner stops working any ideas what this could be?