Mould making for parts 

Excellent Michael . Thank you for sharing.

Great tutorial Michael. Very interesting, 👍 information.

Very encouraging! I might have a go at some of that: I need a load of wee mirrors! Thank you, Michael! I just subscribed - not sure how I missed that before!

Very interesting, great 👍 information. I will try this . Mike

Interesting tutorial. The new parts are very well reproduced. Regards 🙂

Thanks for this instructional. I am surprised that it worked so well. These are parts that are difficult to design for the 3D printer. Cheers Timo

Just doing the same model. The replacement bonnet was a nightmare to get to fit correctly.and took a lot of delicate filing to make it satisfactory. Enjoyed watching your struggles!!! Fortunately it did not have the poor finish yours did and looks ok

interesting video mate should be a big help to anyone who wants to try a bit of casting out 👍👍👍

Interesting mate cheers Graham

Nice press molding. A tip. Put just a little enamel paint in the resin. Not much. For a casting like in this vid, about 10 drops will work. It will slow down that kick off. It will add minutes to your set time. Also adds time to your demolding. But you still get hard resin castings. I've been casting resin since the 90's. Great vid. Keep up the good work.

Great Michael. Where do you get the supplies?, and which resin do you use?