Hai good morning sir...I watched MSA full video.. thanks sir also I have doubt 1. Stability means u said .." external time period" measurements For example today I check one part same part should be check next day(tomorrow) and next week or else different part( new part) 2.pls give one video how to make and calculation with example of bias and linearity
@@QualityExcellenceHub International material data system - IMDS... Its mandatory for most of the automobile vendors to update their material component details.
@@QualityExcellenceHub Take your time sir... Happy to get fast reply from you... This shows how egar you are to learn & teach.. All the best for your teaching service 🙏🙏🙏 Happy learning ahead..
Sir many thanks for the video. Your clear explanations help me a lot. However,I have small doubt to ask. @5.11 says Measurement system should be in statistical control. May I ask how to get a measurement system in statistical control? I believe it should be the PROCESS that needs to be in statistical control instead of Measurement System? Please correct me if I am wrong?Thanks again.....
Thanks for your appreciation. Your Query: It means no presence of special cause in the Measurement System. That is the fundamental requirement of Good Measurement System. Happy Learning Ahead.
Appreciate your video clip. Well done summary. I have a request, could you please post an example of GR&R using Excel if possible showing how the terminology and technical terms are implemented to make it clearer for students to understand the MSA process. Thank you very much!
@@QualityExcellenceHub And one more query for Statistical process control (spc) is any standard available...☺ if availble please mention standard number...
Sir plz explain how to select samples for msa study. If Dimn is 10.0 +/- 0.02 can i take sample outside from this limit like 10.03 or 9.97 for study. Because to know measurement system capable to detect rejected parts.
Sir We have following Grr conducted with good part tolerance variation of min to max. But my selection of parts are not allowed that particular dimensions ng part May I allowed in this selection rejected parts?
For Actual MSA, OOT parts on higher side, lower side, boundary cases and near to nominal cases to be selected, else MSA will not reflect the right picture. Hope this helps. Happy Learning.
Sir from my understanding ur doing msa study for qualifying the instrument. So it is mandatory to chose out of tolerance parts, within tolerance parts of min and Max tolerance. So that u will understand better about the results.
No certification charges. It's free knowledge sharing through videos here on RU-vid. Please let me know if you want me to post video on specific topic. Happy Learning ahead.
Omg!! Did you say that??? Leasecounf of vernier is 0.01 and micrometer L.C is 0.001???? I have studied that for ver it is .02 and for mic it is .01???😕😕
Yes. You are right. Thanks for your clarification. What you have mentioned is for manual VC and MM. I referred to is Digital VC and MM. World is improving my friend. Happy Learning.