MUST DO!!! Screw in Rocker Studs on sbc heads!

Подписаться 742

Просмотров 6 тыс.

50% 1

tapping out the press in stud holes for screw in studs!
#nonamenationals #sbc #cylinderheads
Thanks For Watching!
Leave a like and comment if you want to. Subscribe if you want more content.
Instagram: brandt_murphy_garage
Facebook Page: / brandtmurphy
TikTok: @brandt_murphy_garage
Email: brandtmurphygarage@gmail.com

Авто/Мото

Опубликовано:

22 май 2022

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 13

@christianwise4403 8 месяцев назад

If I could make make suggestion. When tapping go 1-2 turns n back 1/2 turn to break chip off when tapping anything. Watch in cast iron it’s brittle. Use a starter tap, plug and then bottom tap to cut threads for the entire length of the hole Bering threaded. Good video

@jasonkimmel3061 8 месяцев назад

You should probably watch a video on how to properly use a tap. That was painful to watch. I can’t believe your tap didn’t break.

@richardrivera9116 7 месяцев назад

You know to use those studs. You have to mill the boss down. But you can use the cheater stud in the head you are doing.

@grantlucas6678 6 месяцев назад

I wish I was there to show you how to use the tap procedure properly,

@rugged04270 Год назад

A wise man once told me, you should always go 1/4 turn back for every half turn forward, then you will never break a tap. (but do whatever you want just don't hit me in the face with a volleyball again)

@brandt_murphy_garage Год назад

Bruh why did I just see this comment

@rugged04270 Год назад

@@brandt_murphy_garage TBH I asked myself the same thing weeks ago.

@brandt_murphy_garage Год назад

@@rugged04270 shows how much I still use the ol RU-vid

@brandt_murphy_garage Год назад

Wanna change that though

@Backin_Theday 2 года назад

I have used electrolysis for rust and crud removal on small parts but I saw a guy on TikTok using it on cylinder heads. I tagged you in his video comments.

@brandt_murphy_garage 2 года назад

I’ll check it out!

@joshbohner1712 Год назад

Hey man I just did this on my sbc heads all the studs are in the block fits back over them no problem but if I put a straight edge along all 8 studs like two are off the straight edge a very small amount but the block fits fine is this gonna be a problem thanks for any advice or opinions