f frumoasa lucrarea dumneavoastra! da sincer cred ca merita un motor putin mai mare.si tirantii puteati sa le faceti sa se poata lati si angusta.totusi e parerea mea felicitari pt lucrare!
Multumesc de apreciere. Pompa este facuta la Plopeni, si se gaseste in toate magazinele care vand piese pentru tractoare. Am dat pe ea 200 roni la un magazin care vinde piese auto si utilaje agrigole.
While you seem to have and understand the nessesity of knowing how to weld (RU-vid has lots and lots of channels that show you how NOT to do it), your geometry for your rear hitch and front end loader are definitely not ideal. The rear hitch is built very stout, except for the fact that your pivot bearings have only 2 small bolt's each holding the bearing cap's on in the direction of maximum load if you intended to go plowing. Those 4 small bolt's are now the fuze in the system. As for the loader, the pivot points from the top of the loader uprights to the fixed points for the cylinders is way too close together. You're throwing away a lot of your mechanical leverage, while adding a lot of extra stress to the fixed uprights, due to the hydraulics fighting it out with the poor geometry in such a small area. The same can be said about where the lift cylinders attach to the outboard end of the lift arms. You have them mounted inboard of the welded joint where the upper section of the loader arm's, rather than the drop section. Move the brackets and you will put much less strain on that joint. And if done correctly you will loose at most 25~30mm of lift height. I know it's late in the day, but I just had to throw that out there. I'm hoping that even with my critique, you've had nothing but safe operation of your tractor...
