That's a nice looking shed nice to see it went up nicely for you you have more patience than me I never read instructions I struggle to follow them I wing it lol all the best Sam
Robotic Allotment Gardening On A Budget yes I’ve purchased a separate anchor kit. I’m thinking of getting 2 ratchet straps, remove the ratchet and screw the straps down from the bottom and over the roof to the other side. We are in a windswept site so think additional measures are definitely needed
Handy video .. I’ve got one of these on order and was useful to see ... you did well in the timescale and I suppose you would do it quicker if there was another time , thanks 😊
Hello, can you please give me the measurements from the front right corner to where the door closes and matches with the door frame(the left side of the door, not the right side where the hinges are)? Would be me very very helpful for me. Many thanks in advance.
would have been nice to see you actually fitting the roof which is why I came here - Ive been putting one up today & ending up stopping at fitting the roof as it was getting late in the day & as Im doing it by myself I found fitting the roof onto the side panels next to impossible by myself - you really need a second person to help for fitting the roof as its very tricky as one person
@@gballotmentvlogs6400 yes its sorted thanks - I just made the "gulleys" on the roof panel a bit wider by stretching on the plastic - once i did that it was pretty easy to fit onto the side panels - also for referenceI have also built a keter FACTOR too & that is both stronger especially the floor & much easier to build due to a lot less screws
i have seen a few vids cause i plan to buy one (i am still uncertain, im afraid it's too lightweight and concerned about the corrugated plastic -bugs?- and water filtrations some have mentioned)... but i already learned the roof it's very hard to assemble by yourself. you need another person or a bag with sand to hold the other side of the roof in place.
I have built this yesterday but stuck at the roof. Both me and my partner battled and gave up when we lost light. The corners dont seem to line up and just cannot get the panels into the over hang 😠🙈 The rest has been a doddle
I've had to put wooden stakes into the ground under the base of the shed, then bolt through the floor into the wooden stakes. Just don't go through the plastic itself as it will just pull the bolts through the plastic. Use some big washers or a flat piece of wood so it can't pull the screws / bolts through the floor.
I'm buying one. Do you think it's possible to change the door side when assembling? So the door is in the front left side, and the window on the right?