Nice led strip for the hyte y60  

Yeah, not a fan of that either but it does look good.

You have pictures? And whats the screen? Like brand

@@RedRocketModelsits called TURZX Turing Smart Screen , I got some vids of my build of it in my channel

SAME!

@@andrewwebster9779 which size u would recommend me ? or what do u think is the size in the video ?

@@m3lo404 I believe it's the 12.6 inch

@@andrewwebster9779what screen is that

@@deuceizded9143yea thats what im asking

🤣🤣 lmao He needs to change the RGB colors from rainbow. It’s too much going on 😅

I also 😂

Which size?

Did you figure it out

Nobody knows

I haven't at all with my RX 7900 XT founders, tops out at maybe 70ish.

Okay I love how you put contrasting outter rgb lines on your PCI power cables. I would never have thought of that myself so I'm glad I just came across this

You really expect him to list them all? Lol

@@thewind6047 yes? usually people who make tech vids make build spec vids

if you are gonna comment, know what you are gonna say!

Seen this done before and it's better in theory. I would recommend using basement led fans instead. Gives same affect as under glow, put more efficiency and spread.

i have this case and i originally had installed 3 fans on the side there as well until i switched it for two 140mm fans. the only i was able to do it was with zip ties. it worked quite well actually

Power supply is calculated differently depending on build. The cables are extenders, so you still plug in your normal gpu cables, but then you run them into the lian li strimmers.

You can get cables like that from cable mod

@@devinkundert8243 its called lian li strimmer cables

If you look closely… He zipped tie them.

@@slothking3756that’s attention to detail 😂 I didn’t even noticed and I was staring right at them

I think its the cheapest way to fit 3fan, im gonna try this

Well all you need is a plate where you mount the 3 fans on, then you take the plate with them and mount it inside 🎉

ru-vid.comV3xWqiRxQ5g?feature=share

the size is 1m

You can plug it into your motherboards led header and use your motherboard lighting software to control it

Lian Li makes them, they're called strimmers.

get a splitter

They daisy chain so you just plug one into the next. I actually purchased a splitter and ended up not using it as one came in each pack. I used the 3 shorter strips to do what you did on the bottom but was also able to continue up the side of the fans on the right and the 3rd strip goes around the fans to the left of the GPU ending perfectly where the bottom strip begins. I like what you did, but my 3 strips look better, in my opinion. Wish I was able to add a picture here.

I am dealing with this same issue... only half the Strip lights up on boot up. From my research, you should connect the Phanteks M1 strip to your MB. However, I have mine connected to the lian li controller, which also runs my lian li fan/rgb. I am running SignalRGB software and have added the additional LEDs so they light up shortly after boot up.

@@makstapg yea i found a way to almost light up the whole strip with the help of lian li connect software and the 10cm part of the strip that still didnt light up i just hid behind my gpu since i have a vertical mount and u cant see behind the gpu

yes, they are lian li strimmers

Yes it is an argb connection