yk this video is about to get me going. I'm going to start a small business, or at least try to - for making forged carbon trim, and ill definitely use the way you did it because this looks amazing. Thanks!
Another trick get two pieces of wood place fibre down to make a sheet press then remove gently now you can place it like cloth becarful as it will fall apart use a sheet of paper to lift it up
I did my control switch covers now did the same but with vac bag then did another resin coat before sanding so loads of sanding to get level and flush good clean then 3 lots of resin coats to get the finish left out clear spray coat just polish up looks good after it was all soft fluffy carbon lol
@@HarrodsGarage still got my front splitter to go over again lol Iv message lots of eBay sellers to ask if it’s soft or cut hard bits but most say it’s soft they sell it’s a pain to do just big fluffy mess and cost £40 still
@@HarrodsGarage going to sand down gently and pour resin over it and add another layer then pour over again to see if better. It should have been hard chopped up stuff lol
