I have a Honda A c c d i a a d drove i for a miles i keep on getting the D tc Freeze data stored in the computer but will it pass the smog with this error
Thanks my Chevy equinox 2015 the radio goes off and on but recently the speed monitor won't read what I'm going even the one that is clockwise it shows I'm going 30 miles faster it won't show the tires air information do u have any suggestions then a trouble code light I've used the same trouble code reader iit work before but this time it says what this video says. So if u have any info I would appreciate it thanks a million videos like yours help females like me ..I have no clue on cars ..
I have a 2007 Honda Accord And i have the powertrain D T C Store and the computer's data Will it pass the smog with this air I really drove the car for miles and still gives me that same evap system powertraining D C T
My battery was recently replaced. That would clearly effect all electronics that are normally always on, like the station settings on the radio. Is there a Reset that should be performed after replacing the battery? thanks. [Subaru Outback, 2011]
Yes I would like to know why it would give this after I fuel injectors replaced in my car? My engine light came on too get these replaced and it was a code. But when it came on this time we got this message! Thank you in advance for your information. And my car is a 2006 Dodge Charger!
On my 2012 Dodge Caravan, I changed both the thermostat and driver's side blend heater door actuator (AC/heater under dash) because of clicking and operation of controls. afterwards, I cleared the DTC codes with reader. I've driven the car since May for about 200 miles. Still my dtc reader says no codes detected and my car fails inspection sticker. What are my options/reason why/how I can proceed to get it reading again so I can get inspection pass. Thanks
@@whyingo7964 It's a 7 yr old Innova 3100 hand scanner/reader. It has I/M Monitor Status icons. The manual says it conducts I/M Readiness Monitors. I don't believe I've used it. Perhaps an idea from you would help? Why do you ask? Solution?
I've driven the van since May. I changed the blend heater door actuator. The clicking did stop, but the DTC codes are never registered even after driving since then - hundreds of miles. The car failed the inspection when they used their DTC code reader at the station. It says something like: "Unable to find codes stored in vehicle computer". MY DTC reader showed me a yellow light with the EV symbol blinking. What should I do next? A dealer might charge over $1000 to fix it.
my lincoln mkx 2008 drove to the repair shop to replace tss and oss after installing the vehicle won't go into drive or reverse. it says.... powertrain dtc please help me out here
I have that code , but i try to start it but it doesnt want to stay running the battery has been out of the car 4 awhile about 3 to 4 weeks , it is getting gas
I accidentally cleared my DTCs and FF because I have a new scanner that haven't seen since last year and didn't start from the beginning as I should have and tried to wing it. Ooops. So, yes, I will have to do some driving.
p code was coming up cause new secindary air pump and camftshaft sensors were replced. today i saw no code popping up on inmova scanner, exept no dtc codes present . all solid green lights. does that mean engine s fine or reset or somthing??? thanks for your help
@@HVAC_Mechanicines showed red. So what it means if it showed Red? new shows powertrain module and dtc and frame freeze shows up. my car will crank but no start.