Whitewall covers were on eBay, just search the Internet for 'portawall' or 'atlas' whitewall covers and there's some company's that sell different sizes as a set so you can do front and back wheels. Really easy to fit, search RU-vid if your stuck and there's some tutorials and hints in places that sell them!! Hope this helps.
+Paul Goodey didn't change the jets, it really made a very minimal difference in the performance, I did read somewhere that one head is jetted smaller than the other but when I checked mine they were both the same so I left the carbs all standard.
+Paul Goodey I know the exhaust pipes are different sizes just where they come out of the head, the one nearest the back of the bike was smaller, most probably needs a bit more of a restriction, the only problems I had with mine idling was when I tried to start it with no air filter fitted, it wouldn't even tick over. Glad you like it.
Espen Sandum I went 2 sizes up on width of the tyre, that's the biggest you can go on the standard rim, can't remember the exact size tho, rear mudguard off of eBay.
Not Real just LED ones, rear ones from an American company called oznium.com front are just strip LED's off of eBay, both come with sticky pads on the back so they can be stuck pretty much any where.
peter alafe all off of eBay,,, pretty sure you can use the original front one and just cut it down,, mine was snapped so bought a replacement plastic one and shortened the metal frame that’s in side it so it sits closer to the wheel.
Yes removed the original and welded two tags to the inside of the frame to take the springs, seat bracket then bolted on under the same bolt that holds the tank on.
+Matt Blackk Wow thanks for quick reply! A real beauty you have made thats for sure! Something else I should know about the Shadow? I have a 125cc already, just want to build a bobber as a prosject
+xTrAx I used the shadow as it looks a lot bigger than a 125 and has a v twin engine so it fills up the engine bay nicely, you could cut the back box off and have 2 Seperate pipes but it would be very loud, up to you tho.
Sarders front one is the original cut down, I cut the metal bracket down that goes inside to get it closer to the tyre, rear is a plastic one off of eBay, I welded a bracket to the swinging arm to mount it so it's all ways in the same position to the tyre.
Petter Lerli eBay,, search for atlas or portawall I think they were called,, or search on you tube and there’s some tutorials on how to fit them and where to buy them.
Telman Ride it's the original exhaust, just cut 6" out the middle and welded the back bit back on but at a different angle then rubbed it down and painted in high temp paint and wrapped the front pipes.
Glad too see that! Was thinking of doing the same but was affraid of loudness, this sounds perfect considering the engine size. Did you fill the end tip with insulation and a perforated tube?
