Onewheel GT Gradient Tracking Firmware and Torque Headroom Update 

Here's my unsolicited feedback 😂 Totally get it, but I would also say that I used to feel the same way and have zero regrets about updating. But it depends on what kind of rider you are. If you cruise flat pavement, pre haptic buzz might be your thing since the buzz can get annoying. If you ride trails however, there's no comparison. Setting up a custom tune (or multiple) to your liking, and the absolutely smooth riding behavior after updating makes the board feel like a free performance upgrade. Gradient tracking in particular let me take lines on trails I didn't even consider before. The one caveat would be if you plan on getting new angled rails. Do that first and re-level the board. Then update.

@@humbertoduenas89 I’m so close to doing it 😬😬😬😬

As of now no one knows. If you are running the pre haptic buzz firmware it breaks a lot of work arounds though

I went on an 11mile ride yesterday to test it out and it seems to have broken hard breaking with custom shaping. I primarily ride Flow and can hold a hard break pretty good, now into a hard break it almost releases and forced the board to tail drag mid-break. A little bit scary because I wasn’t expecting it, but when I reset Flow to factory settings it fixed the issue. Still testing tho. I guess 11 miles wasn’t enough.

Try brining your gradient tracking degree down or turning it to stock

Gradient tracking is too high. Though this could be useful for bent rails that want a higher nose

@@thewheelneil1379 Gradient tracking angle is adjustable. If your nose is too high adjust the angle or turn the feature down all together. I ride with WTF Standards and I havnt had any issues. It started off a little high, and then all I needed to do was adjust it a bit. now its AWESOME!

@@josephcase5435 totally. I agree.

Hi thewheelneil I have standard W rails and wonder if you could give me a little advice on setting him up I had them on 3° nose up with the 3.0 custom shaping upgrade. So once I downloaded the firmware update, I basically went in and set all the ride modes to 3° nose up tilt after download completed but haven’t taken for a ride