Part 1 Shower pan pre slope pitch 

Great tip on making two pre-slope strips from one thicker piece.

Thank you for this video. Great job.

nice job Hector, good video.

Good job

You did a good job so far...more vids?

Hector you did a really nice job on prep. I really think with that talent you could of float it with out the sticks. And leave out all that extra work cutting the strips then removing them filling in the gaps after u remove them .i prep exactly like u with paper chicken wire but I do all my detail work without the stick some time them stick cutting with saw are not always exactly the same end up w bumps. But I guess they can be scraped off . I like to drymud my outside diameter level about 4 inches level all the way around then work it to drain and play w it till it’s perfect. Try it without the sticks Nice video

Hector you never use Douglas fur with any concrete or mortar it will rot you have to use PT wood , besides that good job my friend.

Hell ya

Like your presentation and calm demeanor Hector............tell me, is your drain flush to the floor or does it sit proud of the flor by 3/8 ths an inch? thank you

I'm a DIY . Are you using concrete for your drip pan?

If you have different height up front, your tiles would not match in height as you go around the walls, right?

Once your second mud bed went in yiu were almost level with your hop up.

Was this for tile or vinyl non slip shower in the end? I assume you must use this prep method on a ply floor substrate?

That doesn’t like to pay 😂😂😂😂

Its called quick shower pitch. 42 with taxes at home depot. Save hours of prep.

Woodglut comes with very useful plans with all the details you need.

Save yourself the bullshit and buy a Quick pitch slope system. You are probably saving yourself 15k doing shower yourself so what's the big deal spending another $30.

Lmao. I don’t even know what else to say