Part #3 Suzuki GSXR 1000 transmission install. Is the noise still there? 

Just wanted to say, thank you so much for such an epic video. I've been building b series Hondas for a few years but have 0 experience with motorcycles. So when i bought an 05 gsxr 750 that was missing 5th and 6th gear i figured, ill figure it out. Well to my surprise my maintenance manual does not do a very good job of explaining the transmission swap. I've researched and watched enough videos over the last 2 weeks to be able to supplement what the manual seems to be lacking, however i did not have a super confident feeling going into installing the new transmission. I just had to many small questions. I got the old trans out just fine, and made lots of notes and took lots of pictures, but still just seemed to be missing the step 1. 2. 3. Of installing the new. However after watching your video, taking ss along the way and making notes of the answers you gave to questions i had, i feel super confident in me getting the new transmission installed tomorrow, and being back on the road. And that's 100% thanks to your no corners cut step by step video and experienced explanations. So thank you for the epic content and fantastic job at sharing your knowledge and expertise. I look forward to shouting your page out when i post my video of my first ride after the install tomorrow.

Great video series. I have a 2006 1000 with under 4700 miles. It has a low-end rattle and the clutch won't disengage with the lever pulled. Trying to find an ethical, competent, responsive mechanic in the Boise area. I had one mech tell me it would cost over $6K to split the cases. He said replace the engine. I'm relieved to know it SHOULD cost far less than that. Thank you.

Thanks for the interesting series. On my 750K6 the gear sensor always reads 2 in 1st gear until it warms up a bit, than it works correctly.

Is it possible to pull the transmission without dropping the motor ?

I have a 2004 gsxr 1000 I’ve noticed that my transmission wines just like the one in the video when riding, I assume that’s normal? And the top end sounds pretty loud for my liking I don’t know the last time my valves have been adjusted

Hey, I have a 07 gsxr 600 and my chain broke while riding. In the process, it bent my push rod and broke the water pump. Had all that fixed but now when I start my bike, the clutch engages but the bike won't move no matter what gear it's in. I raised the back tire off the ground and the wheel spins but does not move faster when twisting the throttle. Added a new clutch cable but that didn't help. Checked the throttle cables and can't see anything wrong. Removed the clutch but didn't see anything out of order and no teeth are missing or broken. Any help you can give me would be greatly appreciated. I'm dying here!! Lol

How u charge to rebuild my motor on my 01 gsxr 1000

you want to rebuild my 01 gsxr 1000

why this engines in k5/k6 1000 rattle so much? i have k5, the same rattle noise.