Perch Position and Pick Up Point | Programming the FANUC LR Mate 200iD | Part 2 

Definitely easier than it was 20 years ago. Progress makes it more accessible for more people to learn how to accomplish this kind of programming. It was fun back then and it still looks like fun.

I would have added a position right above the puck. That way you can have a slower more accurate position when it actually moves to where it picks up.

Need part 3 please!

Nice Easy training video. I hope to get freed up so I can start putting out more content like this.

Can we see tool tip location calibration for different end effector. Also I think the videos could be lit longer with more steps! Thanks a lot for the content!

I assume you can run it via G-code? Might be just as fast to measure the rough offsets and hand-write a G-code file on a laptop?

Where is the next video

Hanzhen harmonic drive gear , over 30 years experience , robot joint , strain wave reducer,

Damn I hope you make more of these, very helpful man

from india

Boom! Please do Robot loading & unloading on machine in machine! Fully teach the auto cycle!! Request From India

magnificent , is it the same way for AAB IRB 6700 ?

Where is the part 3? I dont find it.

what happened to the " next video"

In Finland we call this @ miukumauku

More more....

Nice

Fanuc - Robótics - Automação : Future - Tudo - Robótics : New - Sistem : Hi - Speed - Movimentos - Outro : New - Sistem : " Controller " Movimentos - Suave - Perfeitas ; Como - humanos : Perfeição ; New - Dois : Sistem : Introduzidas : Ficou - Perfeita ; Fanuc - Robótics : Ano : 2030 ; Ano : Robótics : Global - Fanuc - 2030 ; Top - Top - Top .

I was a robot, years ago in the dark ages (150W incandescent light bulbs) of manufacturing. 🤖

học lập chương trình