Peugeot 308 1.6 HDI FULL Service Oil & Filter Air Fuel Cabin Filters Service Light Reset How To DIY

Подписаться 22 тыс.

Просмотров 175 тыс.

50% 1

Here is the full service on the Peugeot 308 1.6 HDI diesel model years 2013, 2014, 2015, 2016, 2017, 2018, and 2019.
If this video helps then please support me by subscribing and liking the video, thank you!
Sump plug size is 21mm, torque requirement 34Nm
Oil filter housing 27mm, torque requirement 25Nm
Oil capacity 3.8 litres.
Air filter:
There are 3 T25 Torx screws along the front and a metal clip on the side that is easily done by hand. Make sure when fitting the new filter that the edges of the filter are definitely seated correctly.
Fuel Filter:
Remove the soundproof material on top of the engine. The fuel filter is located to the left hand side of the airbox/intake. Remove all the hoses and the electrical connector. There are 2x 8mm bolts at the rear and this will allow the top and filter to be removed from the car. Once you have removed the filter complete with the top if you lift the centre part by twisting this will allow the filter to be drained. Now remove the 3 T15 Torx screws. Now fit the top to the new filter making sure you replace the seal and fit completely square as the seal is easily dislodged. Push the centre down and replace the Torx screws. You can now refit to the car take care the bottom of the filter seats correctly, replace the hoses and electrical connector. Tighten the 8mm bolts. Cycle the ignition a few times as on a lot of cars this will allow the pre-delivery pump to fill the new filter. Now start the car and leave running for 5 minutes to make sure there's definitely no air.
Cabin Filter:
This is located in the drivers footwell on the right hand drive models just to the left of the clutch. Remove the kick panel insulation with Bojo Tip 3 then the side panel to the left of the clutch pedal. The filter is in 2 parts pull the tabs to remove. Refitting is the reversal of removal but make sure the new filters are pointing the correct way. They have a black arrow on and this should point to the rear of the car.
If you'd like to support my channel please visit my websites and follow my socials:
www.tolly.co.uk
www.cleverproducts.co.uk/bojo-...
/ tollyswift
/ tolly_swift
Thanks!

Авто/Мото

Опубликовано:

30 июл 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 84

@johngalvin6010 Год назад

I was initially looking to change the oil filter. I took it to a garage 6 months ago & they said that all this was done, oil, fuel and cabin filters. You just can't be certain that you're being told the truth so the best thing to do is to do it yourself if you can. Your video shows all the instructions required to do it. Thanks.

@IAMASPANNER 11 месяцев назад

Never chance it if you can DIY, use the best parts available and save on labour. At very least regular oil changes will keep your car running better for longer.

@barry5138 5 месяцев назад

Wouldn't trust any of them. Get it done yourself is the only option 💯

@ChrisAngelov 3 года назад

I'm about to buy this moden 2015 and this video helps me a lot. I have a megane 2 2002 now and i can say that it would not be difficult me to do it :) as i do it on my megane 2. Many thanks for the video.

@brendanukveteran2360 3 года назад

Much appreciated - no nonsense and very clearly demonstrated...even I could manage it now - thanks

@IAMASPANNER 3 года назад

That’s great, thanks Brendan!

@richardmackenzie7231 3 года назад

Recently just got a 308 and this video helped a lot to show ease of servicing hardest part be that bloody undertray

@IAMASPANNER 3 года назад

Working on the ground undertrays are the worst! It means you have to jack the car up way higher than if they just gave you a small access hole to the sump plug like they do on some cars!

@Roosville1 4 года назад

Best service for this car I have seen, many Thanks. I would only add that on the petrol filter it's worth pointing out if you don't rotate the centre you can break the centre rod if you then try to pull it apart. Again, really helpful video.

@IAMASPANNER 4 года назад

Thank you for the feedback! When I’m in my friends workshop I don’t have anyone to record for me which makes it harder to show exactly what’s going on but I appreciate you mentioning it so other can see. I’m so glad the video helped!

@surjitsingh-zh9cd 3 дня назад

Thanks very much save lot money. For everyone who watch this bit sounds missing early on start keep making other parts too later thanks

@Asuka_kj 3 года назад

hey buddy, its a very helpful video thanks

@Sergioml700 3 года назад

That car comes from a Battle? 🤣. Nice vídeo, It helps me a lot. Thanks!!!!

@paalston Год назад

Thanks very much, seems the only one out there for the 1.6 hdi 92 t7

@alexandreleme7473 3 года назад

Thank you sir for your time and your expertise. Congrats

@IAMASPANNER 3 года назад

That’s very kind Alexandre, thanks for watching and the feedback!

@aname5695 3 года назад

thanks bro from Belarus

@adnaneboukerboub9930 Год назад

Well presented thanks for sharing

@gf04rce76 3 года назад

Excellent walkthrough... thank you...... and one handed too .... very impressive..... 😂

@IAMASPANNER 3 года назад

Thank you very much, and yes, can't believe how many jobs I have done one handed!

@vodonnell1 Год назад

Very helpful thank you.

@IAMASPANNER Год назад

Very glad to help!

@mykola_iegorov Год назад

thanks!

@sawomirpienkosz6131 2 года назад

Thanks

@faze_karel 3 года назад

Je vous remercie beaucoup

@arkadiuszkubiak566 2 года назад

THX FOR HELP ;-)

@IAMASPANNER 2 года назад

You’re very welcome!

@ufs910 2 года назад

Vielen Dank, jetzt kann ich meinem Onkel etwas helfen.

@IAMASPANNER 2 года назад

Ich helfe sehr gerne!

@abderazakhaji8276 Год назад

Merci beaucoup

@IAMASPANNER Год назад

Vous êtes les bienvenus 👍

@kaloyanski85 Год назад

Many thanks for uploading the video! It is very helpful for DIY! I see you are having good practice to replace screws and washers. Do you have the screws and washer sizes and norms?

@IAMASPANNER Год назад

Glad to help! I don't have the sizes, you'd just need to order a sump plug for your car. If you give an auto factors your registration number they'll be able to find you one.

@michaelspafford5936 4 года назад

Hi. I've been doing this by myself for a while. But i cannot change the air filter. My box has a mass airflow sensor on it(i think its called). I snapped it once. I know you twist it and pull it but there is no room to remove it to get the lid off. Any advice? Thanks

@IAMASPANNER 4 года назад

Hi Michael, the MAF sensor is the bit you can see around 4:16 with the part orange connector. Is there a sensor in your air box cover or something?

@mutzeglatze1434 3 года назад

When you screw of the oil-filter then a lot of old oil will come out. So i would close the screw at the bottom after oil-filter change.

@IAMASPANNER 3 года назад

I agree however the amount of residual oil inside the engine means you’ll never really get everything. As long as the car is maintained regularly it shouldn’t make any difference.

@mullahosk585 3 года назад

@@IAMASPANNER What about the old oil that never comes out due to the ingressed sump plug? Won't it contribute to the gradual accumulation of dirt that will inevitably block that turbo filter mesh?

@IAMASPANNER 3 года назад

If this is an issue then follow service intervals or change oil more often and before changing the oil maybe add an additive that helps flush the oil.

@driverc6602 3 года назад

In the lubricant advisor it says oil capacity is 3.75 (with oil filter) i guess? . Can you please tell me is 3 litre enough to get minimum oil on the dipstick, or 3.25l maybe?

@IAMASPANNER 3 года назад

It probably would be, there’s usually between 0.5 and 1 litre difference between minimum and maximum.

@okiesib Год назад

how often should a DIYer do this to their car?

@thecontrolpanel1 3 года назад

Whats the clicking sound when the engine is running? I have the same car and it sometimes makes the same sound. Is this common on these models?

@IAMASPANNER 3 года назад

Most engines do it, it’s usually just the injectors or something electrical

@TheChampionChimp 2 года назад

SUGGESTION! Remove the oil filter first before draining the sump as it allows any impurities from the oil filter to drain into the sump before the oil is removed.

@IAMASPANNER Год назад

I usually leave the oil draining while the sump plug and oil filter are both removed but you are correct it is good practice to remove the oil filter first.

@demon23ro 3 года назад

Hello there. Thanks for the video. Very useful. Are there any frequent known defects with these engines ? I am looking at buying one and i was wondering if it is safe to buy one that already has 200 000km on bord. Any feedback would be much appeciated. Thanks !

@IAMASPANNER 3 года назад

This engine is in a lot of cars and I’ve seen plenty with over 200k miles on the clock. Just make sure the belts have been done if you’re buying at that mileage. They have quite a high service interval for the belts and if they fail there’s a lot of work to fix them or it may even destroy the engine.

@snotdweiler 4 года назад

👍

@coldwatertap8424 3 года назад

Is there any chance you could link the filters and everything you need in the description?

@IAMASPANNER 3 года назад

I don’t have the paperwork anymore and I’m surprised I do usually put part numbers in the description. If you check who your local motor factors are you could try calling them or even get a quote from Halfords then shop around. Euro car parts website would also show you the part numbers just by typing your reg in.

@mullahosk585 3 года назад

Which grade oil is best for the 16 valve 1 6 hdi engines? I hear they are notoriously delicate

@IAMASPANNER 3 года назад

Hi Mullah, I haven’t heard this, unless it’s an oddly specific engine generally we use GM Dexos 2 which covers most cars including Mercedes long life and even VW PD.

@magdalenawereda8753 2 года назад

5w30 c2

@hamzadjaafri9839 2 года назад

Thanks for the video . How many horse in this engine ?

@IAMASPANNER 2 года назад

You’re welcome Hamza, 92bhp according to a quick car check.

@sky4kino943 2 года назад

You wouldn't know by any chance where is the power steering wheel fluid reservoir is located on this model? I just can't find it to check the fluid level. Thank you

@IAMASPANNER 2 года назад

I don’t know off the top of my head but I’ve tried to Google images. It looks like it’s a black cap with a red steering wheel on but the pipe looks short so it may be pretty close to the steering rack and lower down in the engine bay. From what I can see briefly looking the power steering is the electric type.