Piaggio Ciao - Engine Rebuild --- Timelapse 

Thanks man!

I'm so happy to hear that!!

Yeah... I was a bit worried at first but I've checked it and everything was just fine, also the threads. I had a hole in the table and it helped me to drive the ball bearings on place :)) I appreciate a lot your feedback! Thanks man!

@@timbuildstuff Nice video, but I agree with 3FEET. The cranchaft can get bend when hitting it with a hammer because the conrod is not alligned with the center of the crankshaf. When hitting a bearing you should have support between the 2 counterweights of the crankshaft.

@@BlackBull1t2 you are right! When I put the new bearings the shaft was frozen so I could drive them on. But yeah, thank you so much for your feedback!

I only used gas to clean all the grime inside and outside the engine, disk brake cleaner and rust penentrant for some bolts.

Also the old trusty WD-40 :))

Ja, das weiß Ich! Vielen dank!

you need to bey more specific. did you test if there even is a spark produced by by the ignition coil? screw spark plug out, connect the spark plug and touch the threading of the spark plug against the housing of the motor. if there is no spark jumping from the two spark plug electrodes while the flywheel ist turned, then zhe ignition coil or condenser is fucked up

Hmm... you have to make sure the spark plug is working properly and you need to take the spark plug off with the wire on it and put it on the cylinder head where you have ground and then crank the engine and look if there are any sparks. Another problem can be with the carburetor, clean the air filter (mesh), and also check if the jets are clean. For that you have to open the carburetor and clean it. I also had an issue with that little floating part that keeps the level of the gas and oil mixture in the carburetor. I hope it helps! ;)

Soon ;)

Hmm, you can try with some wd40 or bolt spray and let it do its thing. If that didn't worked, go for heat, but first take the seal off. I hope it works for you!

@@timbuildstuff Thanks !

@@timbuildstuff Maybe use the right tool?

Just buy the right tools! Look for a flywheel puller piaggio ciao. These tools are cheap.

They were looking quite good :)) Sweet man!!

Quisiera ponerme en contacto acto contigo

amazon and ebay

I got mines from several online part shops and I had to wait for some of them, since my piaggio is from '75 :))

Hi! In europe is easier to find one. Try buying one online!

👍