PITCH PERFECT! How to Re-pitch a Jetski prop. pwc Impellers , jet boats, wave runners 

Thanks guys this was some good information. Thank you from Alaska

I used this method on my Kawasaki impeller, I marked the outer edge of the blade near the wear ring in two places so I could make sure the angle at the leading edge, trailing edge, and center matched between all three blades along with the blade height. That may be overkill but it helped me maintain consistency since I was working both ends of the blades. Thanks for the video!

Thank you for your time making this great video you can't find any videos for impeller pitching! I will like to see you work on a 4 Blade Sollas Concord impeller. Aslo in Europe you can't find any tool gauges at all, I make mine with siple paper copies of degree angle measurements. 🤜🤛

Glad to see you back, congrats on 4k subs. Hope you're doing well.

Some very informative videos!! Love it! Not sure why I havent subscribed earlier. Aloha, K

super helpful. Thanks

Nice video , couldn't find the pix . Did send e-mail , thanks

Exact weld Maverick Two great pump shops

i just swapped a 650 into my 550sx. however my impelled is pretty beat up and not allowing me to get everything out of this motor. What impeller should i buy and where?

Bello, pretty good tips and information, so thank you for sharing your knowledge. Would like to know where I can buy this device wich indicates dia correct position of the blades?

What about pitching big hub impeller on trailing edge for top speed???

Where can I buy the pice to pich the prop

How much do you charge to refurbish a solas 15/20? Leading edges have a few small dings. Nothing big

so for high elevation lakes like 6200 to 6300 ft above see level, what pitch degree do you angle the props to?

perfect, I want to have a propeller of your work, how? I'm very far from Indonesia

Thank you for the vid. Question, I have a built 550 that needs at least 93 pump fuel, but I don’t want to run ethonal fuel. I have an ethanol free fuel station near me that has 90 octane and 110 octane at the pump. Should I just run 110 or should I mix the 90 and the 110 to get around 97 octane? Thanks

Question: I have a 1999 merc 120hp jet boat that’s 900lbs with a 18/27 impeller and I’m currently adding 80hp. The manual says wot range is 4,700-5,300 rpm. I’m currently running right at 5,200 rpm. So I know with the added 80 hp I’m going to run into the rev limiter hard it runs an xr2 pump. They only Ofer 18/27 and 22/39 witch is used on 210hp and up. Wat would be the difference between impellers? Would I be able to run the 22/39? Are impellers same as propellers as in a 27 pitch means 27 inch forward travel in one full rotation on propellers. Is that hold true for impeller as well? Any suggestions?more info xr2 pump 184mm. Also the leading edge on these impellers at flat cut is it worth having it edge radius cut.? Handful questions here I know. I appreciate any and all feed back very much. Thank you.

I live in Vietnam. I want to buy this jet, can you help me please?

How to buy this from nepal 1 piece only

Where are you located?

I think you should just buy the right prop instead of adjusting it with a wrench

Hey I have a 2 stroke that needs work do u have Instagram or Facebook so I can contact u

Which tools are needed to properly do this job. Can you provide links?

I live in Vietnam. I want to buy this jet, can you help me please?