Poles sinking into the ground leaning Coleman, Best way, Intex metal frame pool 

Lol babe grab the brick ill hope this 2×4 dont slip 😂😂

I made a contraption using a 4x4 with two 2x4 on either side that lifted both sides of the connector at once.

Years ago I adjusted a 15" one by bracing my left arm under the rail and locking it with my right arm. I lifted it up and had a bunch of crushing in my shoulder. Your method is 100x smarter.

If that floor jack or 2x4 give way... your going to need a new wife.

After paying to have our land leveled, husband and I had to relevel the whole pool because dude did a terrible job. Thanks to your video, we didn't have to drain it. Thanks so much for the idea!

But if that would slips off, isn’t going to shoot up in your face???

Lesson. Don't cheap out on bricks. Buy Pavers . Also don't let them touch pool and have them flush level with ground.

Releveled my pool twice doing this(going around and adjusting height). This works great. I notched my 2x4 to lock into the joint. Definitely use pavers

Thank you for sharing my husband put sand down leveled the ground it was perfect last summer. However this summer we just refilled it and its unlevel.

Thank you! Great plan, as i have a couple of sinking legs due to the ground getting wet from the splashing!

Always try to use 12×12 pavers if possible on any type of above ground pool over 10k gallons

I wish you could see the top of the board better. Can't really tell where you put it.

Thanks for your channel. 😊 I really didn't want to drain pool after Rain. Your idea helped me tremendously. A couple of posts had dropped. Thanks again for your help.

Be careful you dont rip your liner with the brick.

I have the same problem. I used sand under my pool and one side sunk within a few months. I'm draining it because my cover ripped last fall so nows the time to level it. I'm gonna get some pavers to do this under 7 of the posts, but I'm worried the pool will contact the pavers and rip. I'm thinking of putting some roofing rubber between the two materials.

Honestly I wouldn't use brick because the friction of the pool could tear the lining. We used old tennis shoes on ours and it was great.

Thanks for this!!! We drained it halfway and picked them up.

Exellent help indeed sir,very usefull indeed ,steve from the uk

Brilliant idea. Thanks for sharing

You’ve helped thousands

Cool idea reminds me of the baptismal you took out of the church

Great idea, simple and effective!

Excellent idea!!! I wish you would have done this 3 years ago!! Too late for me!! Btw, thanks for blocking the Ms. adjusting the brick!!!

Legs to ours sank into the leveling sand. Still think I'll drain mine some before I try this.

Where did you get your pump

You need bigger pavers. Bricks won’t to it. Also before assembly paint every piece of metal with flex paint. Mine rusted out and legs only lasted 3 seasons. You will get wasps making nests in the liner holes. Put dryer sheets in each end. They don’t like the odor and will stay away.

Temporary fix. I did that and 2 months later window started leaking... Which progressively got bad quick Lucky I didn't have a blowout.

Use 1/2 plywood prior to filling pool.....................bricks are too sharp against the liner material.

Hello Thanks for the video! Is that a heater beside the pump? where would i get it?

How great! Thank you for sharing!

My question is are the legs level (checked with a level) or is this just the relaxed location of the legs?

Thanks for this idea!!!

Thank you so much for the video. This method fixed my pool!!!

This has been done before and better!

Greaat way to break your pool.