Porsche 924S Clutch And Short Shifter Install

Подписаться 1,4 тыс.

Просмотров 1,3 тыс.

50% 1

Porsche 924s Clutch And Short Shifter Install! This was a job that I knew I would have to do since I bought the car as it had a major "clunk" when going on-and-off throttle. The stock clutch rubber dampener had broken like they all do from age and use. The new clutch is a more traditional design having a spring center that will last much longer! Now the car is a total blast to drive and being enjoyed more often! Next up is to fix the rear wheel bearing.
Parts sources:
Pelican Parts: www.pelicanparts.com/
Only 944: only944.com/
944 Online: 944online.com/
No Start video: • Porsche 924 NO START a...
bhbtangents
#bhbtangents #porsche924 #porsche944
If you found this video helpful or simply wish to support the channel further feel free to donate to the "Tip Jar" via the paypal link below! Anything is very much appreciated!
www.paypal.com/donate?hosted_...

Авто/Мото

Опубликовано:

11 фев 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 55

@recyclespinning9839 2 месяца назад

Just picked up a 1987 924S. Got the factory seats back in. Probably needs engine mounts , as well as general maintenance. The belt and pump were changed, but I have no idea when. .. . The previous owner removed the stock shift handle, so it wobbles.. need that, wipers have to time them on downstroke to shut off, or they stop exactly where they are at 😅. Oh well, I hope im fast learner

@jefft4629 4 месяца назад

Nice video on a not-so-fun job! BTW - my experience with German cars...if an assembly has 200 parts to it, there will be 100 special tools and fixtures required!

@tangentsbhb 4 месяца назад

Isn't that the truth lol! Glad you enjoyed the video

@iamrichrocker 5 месяцев назад

that Pantera is a sexy beast..and am sure you get a lot of double takes when you have it out and about...i dig this channel..keep the great content coming..

@tangentsbhb 5 месяцев назад

Yeah that car definitely breaks necks lol. Glad you have been enjoying

@recyclespinning9839 3 месяца назад

Why's was the seal leaking ,, why!!! 🙄😪

@upsidedowndog1256 5 месяцев назад

What a pain! I was going to stop and check out a used 944 last spring in my hometown. I kept debating it with myself for a month. It was $3500. Somebody else bought it, I seen it driven for a few weeks and haven't seen it again!

@tangentsbhb 5 месяцев назад

A pain but necessary. 3500 is not bad if the car is in decent shape!

@upsidedowndog1256 5 месяцев назад

@@tangentsbhb I highly doubt it was in my little town. I had recently gotten a Crossfire and had never owned a German machine before. I decided not to bite off more than I could chew. Besides, I might run across more bikes in need of some love!

@1234567marks 5 месяцев назад

Really takes me back, same interior as my old 944 (although you have the steering wheel on the wrong side 😂), my cousin has it now and he’s about to do a deep restoration on it, I may ask to buy it back from him when it’s done 🤔

@tangentsbhb 5 месяцев назад

Well if you had the steering on the other side you also had the good looking bumpers and stuff!

@1234567marks 5 месяцев назад

@@tangentsbhb That’s right, 1982, 8v, 2.5, guards red, no power steering, no sunroof, Fuchs alloys, the one that’s getting collectible now as it was the 944 in its purest form, you know I’m pretty sure I’ll buy it back once he’s completed it, I’ll need to be patient though, he’s just completed his Morris minor 1000, it took 4 years, but wow it’s better than the day it rolled off the line 👍

@Null7Mereel 5 месяцев назад

ohhh extra long tangent! hell yeah!

@tangentsbhb 5 месяцев назад

It was TOUGH to get it under an hour lol

@Null7Mereel 5 месяцев назад

@tangentsbhb doesn't bother me, I watch at work, the longer the vid the longer I'm occupied 🤣

@Retirement_Life 5 месяцев назад

Great progress…well, except for those seals! Nice video, BJ. 👏

@tangentsbhb 5 месяцев назад

Oh man the rear main seal leak...ugh

@peteraitken6494 5 месяцев назад

Nice work BJ pity about them seals man after all that work too can understand your aggravation it would equally annoy me aswell but defo a lot better and man it does drive and sound nice ,have a great week wish you well 🔧🔧🔧👌👍❤️🏁🏁

@tangentsbhb 5 месяцев назад

Thank ya! Yeah the seals really suck but at least it drives well now. I guess if I just keep topping the oil off as it drips out, I'll never have to do an oil change! Silver linings!

@peteraitken6494 5 месяцев назад

@@tangentsbhb hahaha yeah there’s always an upside lol😂😂😂

@bchdsailor 5 месяцев назад

A proper car mechanic as well 😏

@tangentsbhb 5 месяцев назад

🤘🤘

@malcolmbennett3555 5 месяцев назад

great vid, well done, I did similar clutch replacement on a 928 as well rebuilt the torque tube; new bearings and shaft. For the RMS, theres a special tool to insert correctly unfortunately you have to pull the clutch etc again.....let me now if you need info on tool :)

@tangentsbhb 5 месяцев назад

Well I can't imagine much of a specialty tool beyond a large ring. I've installed many like this so I was surprised it leaked

@SillyVehicleEnjoyer_ 5 месяцев назад

I've had this funny idea of buying a 2000 accord, and recording myself doing a manual swap on one after owning it for a few months, after a few other videos if stuff goes wrong with it before then. Lol

@tangentsbhb 5 месяцев назад

Not a matter of if but when! 😅

@SillyVehicleEnjoyer_ 5 месяцев назад

Yeah I might break stuff before then, since it would be a first car. XD

@garagecedric 5 месяцев назад

Have you double checked the crank case vent wystem? So it doesn't build pressure and causes leaks ? Shouldn't be an issue, but worth a check.

@tangentsbhb 5 месяцев назад

I havent but I like that thinking. I'll investigate

@SillyVehicleEnjoyer_ 5 месяцев назад

I also had the idea of buying a Honda CB650 RC03 and repainting the entire bike black and tan, recorded and put on RU-vid of course. (I'm probably gonna get so many comments for sanding all the paint off). Lol

@SillyVehicleEnjoyer_ 5 месяцев назад

Either that or dark indigo, and black, with orange details on the black parts. (No I'm not gonna sand one with a perfectly good paintjob) Lol

@tangentsbhb 5 месяцев назад

Do what you want! There will always be people who have an issue with what you do to your own vehicle!

@SillyVehicleEnjoyer_ 5 месяцев назад

@@tangentsbhb, they'll definitely have a problem with me butchering the power door cables on my 06' odyssey. Lol

@anthonydietmeier6524 5 месяцев назад

Gonna watch this again in a year when I get tired of listening to my torque tube bearings.

@tangentsbhb 5 месяцев назад

🤣🤣🤣 In all seriousness though did mine sound OK or too noisy?

@anthonydietmeier6524 5 месяцев назад

@@tangentsbhb I'm far from the expert, but all the forum threads make it seem like they should be nearly silent.

@tangentsbhb 5 месяцев назад

It's so hard to know what I'm hearing in the car. This is my only experience with a 924/944 so I have nothing to compare to

@anthonydietmeier6524 5 месяцев назад

@@tangentsbhb same here.

@anthonydietmeier6524 5 месяцев назад

@tangentsbhb just be glad you started with a 924S. My son was so amused by watching me struggle with my 944 that he bought a 924 project. At first glance its the same car with a different engine. Digging deeper, they are way different, harder to work on, less parts availability, and less info floating around online. If I had started with a 924 I wouldn't be nearly as into the platform as I am now.

@fxr1991hd 5 месяцев назад

Not "separated" rubber cush goes out on them My 944 did the same, thought it was a U joint at first

@tangentsbhb 5 месяцев назад

Well it became separated though.

@MrNiklas1967 5 месяцев назад

Hi buddy

@tangentsbhb 5 месяцев назад

👋

@Null7Mereel 5 месяцев назад

Do they make a lightweight flywheel option for it? With your quest to drop weight it's usually good for a solid 10-12lbs depending on what you find, frees up some revs too.

@tangentsbhb 5 месяцев назад

They do indeed. I'm not really focusing on this engine too much as I plan to swap it in a year

@Null7Mereel 5 месяцев назад

@@tangentsbhb makes sense!

@danmac2925 5 месяцев назад

Did you fix that left rear wheel bearing?

@tangentsbhb 5 месяцев назад

Yes I did. That video will go up next Monday 😁

@robertalexander2506 5 месяцев назад

Don't you just love having to go through all of that for a clutch job? Sucks about the new rear main seal.

@tangentsbhb 5 месяцев назад

Oh it's just the best! 😅

@recyclespinning9839 3 месяца назад

Why was the seal leaking ,, why 😢😢🙄

@tangentsbhb 3 месяца назад

It was a heart breaker!

@malcolmclenton1663 5 месяцев назад

So do you regret buying this car? Maybe time to "cut & run" ?

@tangentsbhb 5 месяцев назад

Not at all. I love this thing and drive it all the time. Old cars and bikes will give you trouble and you must expect that. The timing is usually the worst part