Тёмный

Priming (pre-heat) and failure points of the M1950 / Coleman 536 stove 

Billofthenorth1
Подписаться 694
Просмотров 15 тыс.
50% 1

Safety first when using any stove.
A video made during the refurbishment of the U.S. M1950 stove also called the Coleman 536. I demonstrate a couple of different ways to prime the stove and discuss some possible failure points and idiosyncrasies to be aware of, especially if you are new to these stoves or have an old one. At the end we venture inside the fuel tank for a look around.
It's a good idea to depressurize the stove after it has cooled off. The next time you use it you will then have to pump it up and effectively you will be testing the NRV mechanism and the pump gasket and pressure testing the entire stove for leaks. When you open and close the valve to fill the preheat cup you are also testing the shut off mechanism. That's about as much as you can do to ensure your stove is safe to use before actually lighting it.
classiccampstoves.com/attachm...
file:///C:/Users/Super/Downloads/TM-10-708-M1950-Single-Burner-Gasoline-Stove-19511026%20(2).pdf
www.berniedawg.com/us-militar...
The Receiver by Letterbox, Lightning bugs by Audionautix, North by Silent partner and Dirt Road Traveler by Audionautix are licensed under a Creative Commons Attribution license (creativecommons.org/licenses/...)
Source: incompetech.com/music/royalty-...
Artist: incompetech.com/.

Развлечения

Опубликовано:

 

14 янв 2018

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 37   
@Bill23799
@Bill23799 4 года назад
I was stationed in West Germany with the US Army in the 70's and 80's. We had a M1950 stove that was part of the gear issued with our tracked missile launcher. We called it the Track Stove. The instructions had worn off the side. We burned low octane Army Mo-Gas in it which we also used in our Jeep and M880. Having no instructions we used a different lighting method. I would pump the stove about 20 times then I would open the valve wide open and then put a lit match on top and STAND BACK!!!!!! Haha it would shoot a flame 4 or 5 feet in the air and sound like a jet engine. After a minute or so the flame would settle down and I would give it a few more pumps and it ready for heating up C-Rats. ( well really MCI meals which were C-Rats with no cigs )
@Billofthenorth1
@Billofthenorth1 4 года назад
It sounds exciting. That's pretty much the method for lighting the older WWII stoves that didn't have a priming cup.
@jakel6473
@jakel6473 2 года назад
excellent display of the pre heat priming .
@mikemorgan5015
@mikemorgan5015 11 месяцев назад
The M1950(Coleman Model 536) was never marketed commercially. After WWII, they marketed the 530 "Pocket Stove" (had to be pretty big pockets) which was basically an M1941(Coleman model 520) with no feet and lots of nickel plating and bosses on the fount to mount the grate frame. Neat little stoves but top heavy as hell. All these stoves will fit in the 2 piece aluminum case/cook kit. The one for the 530 is a little prettier and lighter. The 520 and 536 had a fuel/air tube, so they were technically instant lighting. But with that short fat generator that relies on the heat conducting down through the burner bell to keep it hot instead of being directly in the flame as with most Coleman products, "instant lighting" was a term used VERY loosely. Where most folks mess up the lighting process with "instant lighting" is not pumping enough pressure into the fount. The process, as designed, requires a lot of air to mix with a little fuel. When you try to nurse it, you don't get enough atomization and you get big, tall, bright yellow flame that can be seen by the enemy for miles........ Lots of pressure helps with these, but a preheat makes it more idiot resistant.
@wolfkin73
@wolfkin73 4 года назад
Got on of these years ago. Good little stove. Leather cup in pump was bad. Spare in storage was rotten. Check valve was bad also. Made a new check valve out of piece of rubber and used a accelerator pump out of a quadrajet (don't remember if it was a 2 or 4bbl) never had a problem since.
@jerrydonnelly6134
@jerrydonnelly6134 9 месяцев назад
Thank you for help with my m1950 stove.
@Billofthenorth1
@Billofthenorth1 9 месяцев назад
glad it could help
@brianmarkley185
@brianmarkley185 Год назад
love the confined space joke :)
@Billofthenorth1
@Billofthenorth1 Год назад
it seemed appropriate
@2fast65
@2fast65 5 лет назад
Thanks for the info i just bought one it works good but the pump dose rise a little and the lighting procedure helps a lot thanks have a good day be safe.
@nwlady1844
@nwlady1844 2 года назад
Great info, endo camera shots and demo! Thank!
@BluegrassBushcraft
@BluegrassBushcraft 6 лет назад
Great informative video. Thanks for sharing.
@Billofthenorth1
@Billofthenorth1 6 лет назад
Glad you liked it. :)
@squeakychairproductions6813
@squeakychairproductions6813 6 лет назад
Great info thanks
@trevormurphy7041
@trevormurphy7041 4 года назад
Thanks for telling me about the asbestos I was wondering what that was
@davidh8397
@davidh8397 Год назад
The little o-rings shown in the plastic pouch at 7:20 in your video...where do they go? I received a 4 part kit from Old Coleman Parts, but even they don't know where the o-ring goes. I don't want to disassemble the fuel valve until I'm sure what I'm looking for.
@Billofthenorth1
@Billofthenorth1 Год назад
It is part number 9 in the diagram labeled figure 3 in the manual I'll link below. It goes atop the fuel needle which is down inside the fount. You have to take off the generator assembly to get to it. file:///C:/Users/Super/Downloads/TM-10-708-M1950-Single-Burner-Gasoline-Stove-19511026%20(1).pdf
@CC-xs1hh
@CC-xs1hh 10 месяцев назад
I was hoping we where going to light the military burner
@Billofthenorth1
@Billofthenorth1 10 месяцев назад
I chose that one because it was easier to see what was going on with the windscreen/potholder removed. But, Both of them would have been military in their day. According to another commentor, the civilian version never saw the light of day.
@nathanpleli5780
@nathanpleli5780 3 года назад
I'm in the process of refurbishing my m1950 stove, this video has been helpful, thankyou. But I have a question: the graphite packing in the stem, mine has disintegrated on disassembly (so has the spare), is there anyone making/selling them? I could turn one up if had the measurements out of another material like bronze or brass but I don't know if it needs to be strictly made of graphite or not.
@Billofthenorth1
@Billofthenorth1 3 года назад
Try old Coleman parts www.oldcolemanparts.com/home.php or possibly the Fettle box fettlebox.co.uk/index.php Good luck. If you're still having trouble, the folks on the classic camp stove forums may have good advice as well. classiccampstoves.com/
@squeakychairproductions6813
@squeakychairproductions6813 5 лет назад
Hey quick question. I think I need 2 replace my o ring because I it still leaks fuel when it's in the off position. I cant seem to be able to get the t Joint disconnected for the tank. Any suggestions?
@Billofthenorth1
@Billofthenorth1 5 лет назад
Try soaking the threads for a few days with penetrating oil. Clamping the valve in a vise and turning it out by hand, holding the fuel tank seems to work pretty well. The tank gets damaged easily, be careful.
@squeakychairproductions6813
@squeakychairproductions6813 5 лет назад
Thanks for the advice! I'll have 2 try that. It seem they have some sort of locktite on it or something. Thanks again
@squeakychairproductions6813
@squeakychairproductions6813 5 лет назад
Did yours have red locktite on it?
@Billofthenorth1
@Billofthenorth1 5 лет назад
No. I don't think the original manufacturers used anything on them. Here's links to a couple of stove forums where you can get a lot of good advice for repairs. Lots of collective experience with these folks, they know a lot more than I and should be able to guide you to a safe, damage free repair. classiccampstoves.com/ www.colemancollectorsforum.com/categories
@squeakychairproductions6813
@squeakychairproductions6813 5 лет назад
Billofthenorth1 Awesome thanks for the info and reference. Have a great day!
@adamkelderhouse2175
@adamkelderhouse2175 Год назад
I am looking for some replacement parts for my stove, any information would be greatly appreciated
@Billofthenorth1
@Billofthenorth1 Год назад
Depending on what you need: fettlebox.co.uk/ And www.oldcolemanparts.com/parts/Stove-Parts/ I think OCP has changed hands since I last ordered from them.
@jayk3784
@jayk3784 Год назад
저소음 상향식 연소캡잇써요
@yahyaalmeawi7078
@yahyaalmeawi7078 3 года назад
عندي واحد مثله بدون الدفاش او ضاغط
@marzsit9833
@marzsit9833 5 лет назад
nice stove, but the flame control sucks... great for boiling water or melting aluminum but not so good for cooking.
@Billofthenorth1
@Billofthenorth1 5 лет назад
For sure it is full on or off with no middle.
@minnesotaoutdoorsnorth
@minnesotaoutdoorsnorth 2 года назад
model 530 not 536...
@jayk3784
@jayk3784 Год назад
저소음 상향식 연소갭잇써요
@jeromythompson3324
@jeromythompson3324 7 месяцев назад
There's 6 different manufacturers there's Rogers, there's common there's. Fiesta, I can't remember the other three, but it's the exact same stove. The mechanisms apart the gas gives the tanks the feed. Everything is exactly the same between these 6 different companies and Rogers is actually made of in the same factory. That coleman is same town
Далее
Stove, Cooking, Gasoline, M-1942 Modified. 1 Each.
14:57
МНЕ ИСПОРТИЛИ МАШИНУ #shorts
00:30
Просмотров 1,1 млн
Косплей на ГОЛОВОЛОМКА 2!
15:20
Просмотров 510 тыс.
M1950 military Rogers( Colman) stove
15:48
Просмотров 10 тыс.
Coleman gasoline stove PEAK1 400 overhaul
20:43
Просмотров 15 тыс.
Coleman M-1950 Military Stove
9:22
Просмотров 54 тыс.
Vintage 1944 Coleman U.S. Camp Stove Overview from WW2
10:53
ХАЛТУРЩИК
0:23
Просмотров 6 млн
Утро в Нью Йорке
0:16
Просмотров 2,8 млн