Programming replacement BCM for CHEVY CRUZE using wrong part number and no TECHLINE CONNECT SPS2 

Hi excuse my ignorance, but could you also just take the 2 chips off the old board and solder them onto the new board? Great video

Hi there, thank you for sharing the knowledge. I have a question regarding BCM replacement on a 2010 Chevy Silerado Hybrid. I could not find a used BCM. But brand new ones are available. My question is, if I swap the old EEPROM to the brand new BCM, will it work normally, or will the new BCM still need programming using GM MDI and SPS2 after swapping the eeprom?

Hi there. I have a Chevy Captiva 2010. My question is can the BCM be programmed or reprogramming to fold the orvm in when locked and fold out when unlocked like the newer cars. I understand it can be done by relay but i just wanted to know if it can be done via programming. If anyone's got any clue regarding this topic do help.

Thanks for the info. Is it possible to program used BCM when the old one lost

Hello, I have an issue where i am starting up my 2015 chevy cruze and the wipers automatically start for 3-4 wipes and stop where they please. They work fine when i go up a lever(regular speed) and then at fastest setting they work fine too. When i push the lever down for the one wipe they immediately stop when i let go. I also notice there isnt an INT function available anymore. When i twist to go INT quicker or slower it doesnt register. I brought my car to a local mechanic and they thought it might be a bad switch and they replaced it with a new one but still have same issue. They then said it most likely has to do with the BCm module. It will cost me a lot of money to replace it so I can't do it now. Any ideas? Ty

Is there a way to take a blank bcm and program it with the old ones info without paying cor the software ? I have a thinkdiag i thought that would work but their customer service is garbage

Hi, I have an Iprog programmer but can't find information or datasheet to make connections on the board. Would you mind sharing a link for datasheet or instructions, or does the software tells you where to make connections?

What software are you using to read/write the eeprom

Good day to you....I have a problem with my cars original BCM 13579056....(flooded)...but end up with a BCM 13577849.... is it possible to make the same you've done with the eeprom swap... I need to hear from you... Thanks

I have a question i understand the eeprom data transfer with Ch143...but to (flash) other information i don't understand...where and what the IC look like...on bcm. I don't have the other reading tools..just ch143a need other data on bcm because its new...need a simple way out...maybe solder chip IC please help...do have soldering eqpmt

Hi, so the part number is really not that much important as compared to the pins of the BCM?

there is a slight burn mark on the board of my bcm and the pins on my bcm eeprom and the pins seem to be bridged, but everything on the car works except a few of the lights.... if i unbridge them somehow would it possibly fix the problems with my lights? and how do i unbridge them?

sorry to blow up your comments but i need your services, how much would you charge for this?

maybe i could just send you the bcm for repair?