Project Civic EG - Ep 10 : Making custom intercooler piping 

Your custom bead roll looks even better than what the pipes came with 😂

8:22 Those piping flares look GREAT! Never would've expected that from a home-made tool. 9:54 The traction bars did not escape my attention.

Great Idea on that bead roll tool! Makeshift tools are the best!

Nice video. Thanks.

Your channel deserves more views

Great job 💪💪💪

Looking nice

Professional

What are your settings for the welder

My car doesn't have very many manufacturers making performance parts for it, so an airtec IC would set me back 750-800(USD), while the Fiesta ST IC is only 460(USD)... So yeah, I wondered if custom was worth the hassle, and also could hopefully route hot n cold on opposite sides (the few ICs I see ar same side) PeugeotSport 208GTi (vid on my channel) They can reach intake temps of 50-60c just on stock boost btw, not good 🙈

Nice job, looks clean as, u made it look easy. That engine bay is super clean to. I also made some of those vice grips bead rollers today. They work well. What’s that little tool called u used that get the burrs out of the inside of the pipes after u cut them.

What kind of welding setup do you have and how much did it cost?

U made it so easy well done where did u get the piping kit can u post the link pls

What about the iat sensor?

What turbo manifold are you running do you think it might clear ac

I'm thinking about doing the same thing. Do you know if the U pipes will work with an Integra without clearance issues? I'm not sure if the civics and integras are the same.

Sick job on the piping! Do you need get full penetration so the pipes don't crack in the future or can you get away with it?

Do you mind if I ask what you coated your cast manifold with?

Hi. What size is your intercooler? Where can I purchase one I like that size on the EG's.

what size is the intercooler