@bryanhearn9924 Correct me if I am wrong, but the gas cartridge only leaks (slowly) when in the machine, because it pushes the cartridge valve in, right? Disengaging the cartridge from the machine, so taking it out when not in use, should stop the leak. Works a treat in Paslode, guess it should work in this Hilti too, right?
Ive used the Dx2, Dx351, GX120, GX2, GX3, and the BX3 Bx3 is by far the best out of the lot. The gas guns stop running in low temps where the Bx3 will keep working (-30c) The pin hold is amazing...1-2 misses in an entire mag. The only downside to the Bx3 is that you cannot rapid fire as the piston needs to wind up in between shots
My piston keeps falling off? 😅 when it’s working it’s great but when it’s not pain in my ass and wallet 💳 😅😢 miss fire and at times it don’t even fire at all 😐
Im not sure what they cost at the moment, but i think they are over $1000 cdn. you should also check out the dewalt version. it's just as good but does not require any fuel, so it's cheaper to run
I use these guns everyday at work sometimes they work okay have a hard time getting a three-quarter inch pin to hold in concrete the half inch pins hold great in the steel but get a ton of misfires with it especially when you're in an awkward position they are nice when they're working good but they're really crappy when they're not.
