So all plastic do-dads have to be taken off and replaced when removing a shaft? I've got a bubble head driver that I want to remove from a graphite shaft. Thanks for the vid. It was informative!
Just getting into tinkering with my own clubs, replacing shafts, grips, heads, driver adapters, etc... Maybe I'll take this further as I've done a little bit of work for friends. Having said that, any recommendations for a shaft puller?
I've learned different makers use different methods to achieve the same results. I'm a hobby club builder. Place my club in the puller (graphite or steel) before applying the heat. White-painted wood heads are the devil.
If you take out a steel shaft and replace it with a graphite one, How will this effect swing weight since Ultimately that's what I am trying to reduce going to graphite? Also how would I know if the replacement graphite shaft should be a tapered tip?
Most heads are parallel except Titleist, Mizuno, Srixon, XXIO and some Taylor made. I keep shaft ends TT and parallel to confirm fit. If you are going from steel to graphite shafts you will need a swing weight machine to properly weight the shafts.
Are you trying to reduce total club weight or swing weight? There is a difference. Just going to a lighter graphite shaft while using the same head and grip can increase swing weight while lowering total club weight.
When reshafting from steel to graphite two things will happen. You will reduce the club weight and increase the swingweight. To maintain SW you can drill the head or add a counter balance weight.
