#MUST #BMSsettings #lithiumbattery #inverterinstallation This Video is about Communication of MUST Lithium Batteries with Inverter. Batteries are connected in parallel to form a storage bank then RS485 Port is used for Communication.
I have 3 inverters (MUST PRO inverter 5.5kW) connected in parallel to produce 3 phase power. With that, I have 3 PV18-5248PRO connected in parallel as well to create one battaery bank. Do i configure All 3 Inverters to set parameters 14 and 41? Also, should i connect communication cable CAN to COM from 1st battery to the 1st inverter only?
Good afternoon, tell me the settings of the Must inverter to the dyness b4850 battery. I put the ones that are in the battery manual, when the inverter has already fully charged it, it gives an error (3), "battery voltage is high", then a few minutes pass and the inverter charges the battery again and gives the error again. Why doesn't the inverter turn off charging and stop charging on the SAN bus? Should the voltage be set higher or lower? Thanks for the nice info!
Where I can find protocols table for option 41? Protocol 0 is compatible with JKBMS CAN: in BMS app need select CAN protocol No 10. When connection established I have strange issue - invertor attempt load battery for maximum current 115A for several short impulses, may it try sold energy back to grid (but model is off-grid!).
Hello! Could you help me? How can I connect my inverter Must PV18-5048VHM with battery DYNESS B3 LiFePO4 48V/75AH ? After installation it works, but inverter doesn't see battery and doesn't know information about it.
Sorry, this question requires an engineer to answer. Please send your inquiry to service@mustenergy.com. If you have any pictures, you can also send them together. Thank you.
must pro 5.5kw inverter + 200ah with LiFePO4 (pace bms) battery - It is ok when I chose must inverter setting LI ? (PIN ASSIGN IS CORRECT). Other INV Such as Voltronic Inv, I chose PYL , It is ok. MUST INVETER is what protocol support ? for example , Pylontech Protocol?
I just bought two LP16-24100 batteries, and I want to connect them with my axitx inverter. is possible to connect them ? if not .. how can I connect the two batteries to be in sync so when I turn off master battery the other will turn off ?
Hello, this brand of inverter is not our regular matching model. Could you pls add our after sales engineer Mr. Sven and describe your problem details? email: cs-lgy@mustpower.cn
Please I have LP16-48200 battery, and I connect it with my Voltronic inverter Axpert-KING II TWIN. and it stop charging on 98% ? can you help for that please ?
I have a MUST inverter PV 18-5248 PRO and a LiFePo4 Deye RW-M6.1 battery. Help me connect them so that the inverter can read the BMS batteries. Please tell me the cable pinout. Thank you.
I have 5.2kw inverter and the top board is damaged. Is there any possiblity to get new board from your company? And is it possible to get a contact adress email or WhatsApp?