Racer X Tested: Motoseat cover install tips 

i can barely put the sheets on my bed

same with graphics, everyone makes it look so easy. the side number plates are a bitch to do.. even with a heat gun

Something tells me its not as easy as he makes it look.. I'm going to find out when I get my seat cover..

me and my farther fight for at least 2 hours to just tighten a chain

Thanks for the video. Installed a Motoseat and put it on as tight as skin.

I did my seat cover the other day....this video makes me want to do it over again.

he makes it look so damn easy. me and my father fight for usually a 1 hr putting on a seat cover (hand stapler tho)

You the man Travis! Great job!

dude. he went cod style changing staples.

Stainless, Alu or galvanized steel staples`?

What size staples? 8mm, 6mm, 10mm?

I hope I can do the seat as well as you did! Quick Question: What specific staples are recommended (size, material, etc.)? Do the staples depend on the bike? If so, it's for a 2018 CRF450RX.

Reloaded like a boss.

I just did mine, took about an hour taking my time making sure i got it on right. Just work from one end to the other, no big deal. Worst part is the corners really.

ok i get the cover part but what about cutting foam to make it lower and putting a hump in it, could you guys ask him to make a vid on the cover and cutting foam lower and putting a hump in it????

i have been racing for 20 years and im a freak about my covers, i NEVER rest a tool on my cover , cause i dont want grease working its way into the cover. THese covers are by far the best i have ever used, longest lasting and super grip.

takes me like an hour

you can use a hand stapler????

Np, I've just checked at mine and those can be as long as 6mmm easily.

systemic proceedings: great! staples: 10 mm. thanks.

This is the most annoying thing I’ve ever done mainly cuz I don’t have those sockets for the ends and I don’t know how to line them up exactly and I need to use a hand stapler and that’s the worst thing ever

any would do, they just shouldnt be too long so they dont comeout on top. 3mm should be alright

lol did anyone else notice the kid in the background?

Make sure you use stainless staples people.

If only it were this easy

Holy fuck my kx250f seat mold is hard asf every staple folded i had to buy 3 staple guns manual electric and air gun air gun staples were best so pissed literaly about to cry

My local motorcycle shop charges $100 for this job😂😂

Because we all have a $300 stapler sitting around... 🙄

Haha!! Its not even close to being this easy!

Ha proscotter

he looks to rushed and its a sloppy job i wont b beying of him