Obviously you need pin holes in your RX PCB for this kit to work. So well done RM once again providing a half baked solution....Im not sure why they fail to see the blindingly obvious Wayne...?...😳😳🤔🇬🇧 Saving money by not drilling the PCBs
This is why Im sticking to Crossfire...The TX Module uploads matching Firmware to its recievers OTA. Dont have any of this nonesense and you can upgrade RXs installed in models easily...No PC involved...😳😳😏
My Crossfire Module managed to screw itself with an update one time... although to be fair, that was because I had to use a Windows VM to update it, and it has a Mac version now. It was recoverable though.
Ah - ok, so it copies to some memory during the "flashing" from the configurators point of view and then does the actual copy into flash ram afterwards. Thanks - noted for future
