Just got this over the weekend in SoCal from my brother-in-law! Gimbals are AG01 gimbals! I loosened the throttle a little. It was tight in the lower-end.
Anyways, I flashed the ELRS module with a new firmware along with my binding phrase. It was a breeze to setup. Next thing I did is configured a new profile. I created new OUTPUTS for arming, prearm, turtlemode, etc. I had to change my entries in Betaflight for this, specifically under Modes. I didn't change the rate profile on the quadcopter. When I tested it, my drone was twitchy. I found out the ADC filter was set to GLOBAL. This setting causes issues in curves in Betaflight. So I turned it off. You'll see the results in the video. I LOVE THIS CONTROLLER!
16 сен 2024