RC Car Not Driving Properly and Electronic Speed Controller Calibration

Подписаться 182

Просмотров 11 тыс.

50% 1

Troubleshooting the drive and speed controller on an RC car. The initial problem was an unpredictable response to the throttle which can be due to mis-calibration of the ESC, in this case it was two issues: One, the ESC required calibration and two, the transmitter reverse control was not functioning, which became apparent while calibrating the ESC. Swapping out the transmitter / receiver pair allowed the ESC to be calibrated correctly.

Хобби

Опубликовано:

1 авг 2024

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@sethturner6399 Год назад

Thanks really needed this

@josephmorelli3191 6 месяцев назад

Very nice video! Seriously, I have a lot of trouble grasping written directions. Your video was very clear to me. Thank you!

@randomdadstuff1777 6 месяцев назад

Thanks for the positive feedback, really glad it was of help.

@gregmaggert8561 5 месяцев назад

Awesome video thank you

@randomdadstuff1777 5 месяцев назад

Thanks, glad you enjoyed it 👍🏻

@overfly_pt 8 месяцев назад

Great video thanks

@randomdadstuff1777 8 месяцев назад

Thanks! Glad it was helpful

@Ghostcars20 6 месяцев назад

Well I didn't have a break and only forwards throttle so thank you

@randomdadstuff1777 6 месяцев назад

Glad it was helpful :)

@idiots830 7 месяцев назад

After connecting 2 motors to 2 ESCs, without knowing to remove the red wire on one side of the BEC, I connected them together to the servo controller of 1 and tested the operation for about 30 minutes?? So, only one motor worked, the other motors operated randomly, and in the end, the ESC on the motor side, which was working well, was damaged and did not work at all. When I went to RU-vid, I saw a video about removing one BEC. I removed the ESCs one by one, reset them, and tested them. Of the two ESCs, only the motor side, which had been malfunctioning uncontrollably, works. When I turn on the power, the motor makes the same beeping sound that it made before starting, but even when I move the throttle, it works. The motor doesn't move at all. Is there no way to save it??