Messing with the C2x from rc4wd, lengthening the wheelbase a little If interested in supporting the channel, here is my patreon: www.patreon.co... Check out my Amazon influencer store page for some of these products; amzn.to/2NMKTtX
While I'm going a slightly different route with mine, you might want to check out the series I've done for some performance improvements to help the C2X! Great video!
I know this truck is a little different than the TF2 lwb, but it should be close. It looks like they might have mounted the body a little higher. I used the body lift for the TF2 lwb and it created a space between the body and sliders. I flipped the sliders upside-down and that brought them up to the body (I had to remove the innermost bar to clear the body mount). Good call on extending the links, looks better! I hope this helps!😊
Lead stick on weights are hard to get balanced. I've been using Beef Tubes Beef Patties. They replace the hubs, and also are 4mm off set. One ounce per wheel, all the weight ya need down low. Keep up the mad science my friend!!
Not sure if it was a mistake or not but I put scx10 ii axles on mine. Now my front end needs different links. Wish I could figure out a 4 link setup. But I’m knee deep into it and can’t go back. Lol
Could you put longer shocks on the c2x? Always looks like it needs to be higher compared to a d90, with the longer wheelbase it seems to hit the rocks. How much Weight are you thinking of adding? Truck looks brilliant 👍👍👍
What about the lead wheel wieghts? Ive seen ppl sticking them on the inside of the wheel adds low weight and its outta sight been thinking about trying it myself
Ok I'm slow how do I move the front axle forward my steering locks up every time I turn my crawler had this issue since day one all it's done is collect dust because of the fear of burning up the servo
Have you ever put a tf2 body on a scx 10 2 I have a set of mts that were 3 d printed to fit the original mounting holes on the tf2 body but the rear shock mts hit the bottom of bed and will not let holes match up any help you can give is greatly appreciated. You have some many awesome builds. Such attention to detail very talented
I did that once with an scx10 one, not much you can do about it, I just cut holes in the bed fo the shocks to stick through. Dinky RC use to make a anticancer system that relocated the shock so you didnt have to cut the floor, havent seen them in a while though.
@@RCeveryday I emailed rc4wd and their response was "This would work, you may have to use some different length links in some areas." I'm still hesitant to buy as I am not yet 100% sure what other items to purchases or what modifications to use. Upon checking they are the same width and I think with the panhard and rear bracket it will fit. But I'm a little tight on budget and this is too risky for me at this point.
@@RCeveryday I wanted to see if I could mount the 2 door Mojave body on it. Those pumpkins were way to big. Changing the axles brought on more problems than anticipated.
Hi how are you doing see I have a semi truck i run a model car garage and in turn them into rc I need a lil help with this semi truck I wanna replace the motor infant know how