REBUILDING A BLOWN BMW E46 M3 ENGINE (ASMR) 

DYNO!? 😉

Cost for build?

Should have replaced that radiator fan motor, they tend to go boom....

@@Truthseaaker пппшпшппшпшшпп

Crazy, wouldn't even attempt. Good job

Thank u finally someone with knowledge

lol i was surprised they even lapped the valves

Are you going to pay for them to get the equipment to do those measurements? Just some hobbiests rebuilding their own personal engines. You work with what you got.

@@devonsimpson8069 the equipment needed (aka micrometer, bore gauge and plastigauge) is not expensive. 200€ tops. getting the block honed and surfaced, crankshaft polished and trued will set you back another 250-400€. considering that in the worst case not taking care of any of this can result result in the engine being dead on start it's easy costs to justify. If I can do all this for a tiny m43 engine in my home shop, these guys can do it for a much more expensive and powerful block.

@@ElvianEmpire again, you going to pay for it? It's a "DIY" Rebuild. Backyard, anyone can do it rebuild.

but they painted the block and head with silver! This alone added not less than 100hps!

@@aakolov at least 100 😀

Didn't measure rod bolt stretch either.

He use the same part or he change new parts for this engine and block ?

Also used pistons from one engine into a new block with only honing and no measuring

Im confused - 12:08 Didn’t they replace that blown engine block with a brand new one? Or did they re-use the one with the holes in it from what looks like a blown rod?…

@@mro4ts457 they definitely used the one with holes, they wanted to make sure all the oil came out before the first start, that's how you know you got a good BMW engine

@@1mawesomel1kethat 😂Tell me about it lol My fuckin differential is making a whining noise now after I just fixed the brakes and vanos timing. If it aint broke, it’s not a BMW🤣

Not keeping up with oil maintenance

You dont know what you're talking about.If they were any good they wouldn't have a recall of all 2001 to 2003 for new rod bearings.2004 cars had the up dated bearings and mine spun a bearing and scratched the crank.Matter of fact the s65 in the e92m3 the s85 in the m5 and m6 are eating their rod bearing too.When rod bearings are wear items the engines are garbage.

Там вся работа так сделана! Хз какие размеры цилиндров, хз че за поршня, кольца! Фазики старые я так понял конченные! Насос масленный тоже старьё с разбора не иначе, или этот чисто с наружи отмыт, датчик уровня масла тоже старый! Это даже не ремонт, так на продажу подшаманили! Но главное крышки серебрянкой покрасить)))

Дядя Сережа в лесу на колесе и то грамотнее движки делает!

wow you did not see many videos huh?

Why wouldn't they? Con rods are not an item that wears and are only commonly replaced in big power builds.

​​@@matthewjenkins1161 conrods do wear the big end housing is often found to be out of round especially if an engine has knocked a big end out or a shell has spun in the housing also the small end bush can wear

Them youth know them thing hood vuys

Would it not be better to put alot of new parts in engine Would need like new then

Smart man