RecPro RV Powered Awning Installation 

We installed this awning today... Followed our common sense and installed the tube with the black crank pointing down. Then watched your video which shows at 10:12 that you're installing the tube roller with the emergency crank pointing UPWARDS. So, we decided to trust the professional, took the tube back off; just my husband and me in 103 degrees heat, him holding the tube up in the air, me taking the bolts and washer off, and redoing it all...Turned it like you show in the video, Emergency Crank UPWARDS. Just to realize in the end that the tube is installed wrong. Tomorrow we have to do it again and turn the tube with the Emergency Crank pointing down. Maybe you need to address this topic in the video. Thank you.

Just installed these arms and new fabric, I’m sure I did everything correct. It’s all intact, and wires connected Just won’t stop at the REAL max it should be, it has its own set max, it’s not letting ME SET the max. Any advice?

I have a camper without an electric awning how do I go about installing the panel for one?

I was wondering how to know if my RV has backing plates to mount on the lower part of the arm. I know my RV (Braxton Creek Free Solo FAM) Has backing metal across the top, but I am not sure about if there is a place to mount on the bottom. Any advice on how to figure this out before I order one?

Is there a minimum clearance above the door for the awning to be installed without scraping the corner of the door?

does there have to be a stud it mounts too?

Did a few things done without explaining them an example, when he installed the very first bracket he did not state how far up or down the bracket should be on the side of the RV?

Hi. You forgot to. Say. What size of. Screws and for the Assembly bracket for the. Awning and the tubes you forgot the 1/4" 28 screws or metric also for the arm brackets there's no screws size was given because .I dont have the. Old one. To see the size. Sorry

Awnlux W5700. Good instructions on their videos.

Great Video to show "a way" to install a new awning assembly! I assume a manual awning is similar expect for the electrical install. The other thought, could a person use 3/16 or larger pop-rivets instead of the screws (assuming a person has a pop-rivet tool)? And could a aluminum weather wrap be used as well (assuming Rec Pro makes awnings suitable for those types of weather guards)?

So what if we dont have a max? It rolls out then immediately starts retracting. Any suggestions?

Have this coming to replace one that was ripped off while driving. Do I have to use the provided rail to hold the awning or can I use my existing awning rail on my 5th wheel?