Reel and Bedknife Sharpen - Scott Bonnar Model 45

Подписаться 2,2 тыс.

Просмотров 11 тыс.

50% 1

How to remove your cylinder, bedknife and soleplate from your mower to get them professionally sharpened.
How to install and set the cylinder blade to bedknife for proper cutting after getting them professionally sharpened.
Brisbane Cylinder Mower Specialists:
briscms.com/
/ brisbane-cylinder-mowe...

Хобби

Опубликовано:

4 ноя 2021

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист

Посмотреть позже

Комментарии : 11

@planthijac 2 года назад

Thanks, very good instruction and what a immaculate restoration!

@SBRenos 2 года назад

Thanks Joseph.. I’m sure there are other ways of doing this. This is just how I go about it 👍

@damienwatt358 Месяц назад

Hello i have an old suffolk swift push mower. I am still confused, does back lapping also sharpen the bedknife or does this only sharpen the cylinder.

@SBRenos Месяц назад

It will do a bit on both.. Think of backlapping as liquid sandpaper being squished between the cylinder and bedknife which results in sharpening.

@LachlanRichardsonNTL 2 года назад

Engage the clutch so it has the resistance from the motor??

@SBRenos 2 года назад

Thanks Lachlan, I did actually do this but edited it out. It still spun.. When I assembled the mower I used an impact driver to tighten the nut, I think that’s way it was so tight..

@robertsaez3587 2 года назад

Did you have your reel sandblasted then powder coated then sharpened?

@SBRenos 2 года назад

Yes.. I had it sandblasted, etch primed and then painted, but if you were to have it powder coated it would be the same, sandblasted and then powder coated 👍

@robertsaez3587 2 года назад

@@SBRenos thanks for that mate! Just quickly I have a SB40 electric and trying to source new bedknife would you know anyone I could source one?

@SBRenos 2 года назад

Corbin from Brisbane Cylinder Mower Specialists should be able to make you one.. Or at least point you in the right direction.. Look him up 👌

@robertsaez3587 2 года назад

@@SBRenos thanks heaps mate got in touch them and they will make one for me cheers!