The issue is still be experienced in the ETA 2824 ETA 2834 ETA 2836 Sellita SW200 SW200-1 and it is advisable to avoid hand-winding your Sellita caliber watches as much as possible
Ideally, shouldn't the watch go through a full service? Those broken off teeth are hiding somewhere and might cause more trouble than the watch not winding.
A very informative video. One question, I have read that it is dangerous to manually wind the Sellita SW200. Could this problem have been the cause of this repair? Does the replacement part seem to be made of another material? Once this part is replaced, would the movement be exposed to this happening again? Thank you very much in advance for your attention.(Sorry for my bad English)
It's true that there have been discussions and some concerns raised about manually winding the Sellita SW200. While it's generally safe to do so, excessive or forceful winding can put undue stress on the movement components, potentially leading to issues. However, it's important to note that this is not a common occurrence, and many watch owners manually wind their SW200-equipped watches without problems.
@@SolimBD Thanks for your reply, I didn't know how common it was to encounter that fault, anyway I think the design at that point is not completely resolved.
Hello Solim! Do you know if the powermatic 80 that is based on ,the eta 2824-2 has fixed this issue or its ratchet weel is still that soft too?Thanks in advance!
