Thanks for the clip. Worked perfectly for me. £230 saved at Audi by DIY and £13 for a part off eBay. Only thing I found was although you have the rear light out that was something you don't need to do to get this job done in under 30 minutes all finished.
Thanks, managed to do it a second time on the same sensor as you, I think it s a common problem with that spot with humidity because I replaced the aftermarket I bought a year ago with the original one I've changed and it works perfectly fine
I'm about to tackle this job myself, weirdly its the same sensor i have to replace, having a look in the back myself, i can undo the screws you mentioned without taking the back light off, do you have to remove the back light to peel back the bumper trim ? or can you just leave the back light and just undo the trim scews only ?.
Hi there wondering if you could help me please I'm just retrofitting this kit and if I'm correct there isn't any difference in sensors is there,, there all the same. And was wondering if you remember how the holder for the sensor looked like as I'm in the process of getting the sensors off ebay and just found holders but didn't no weather you retrofitted this or it came as stock
Hi, good vid, I've got a sensor kit for my car I'm fitting soon , mine is a 2006/7 a4 avant b7, do you know if its possible on mine to fit the sensors just by pulling the top of the bumper forward like did in this vid, I'll be drilling just below the top ridge of the bumper hopefully missing the impact metal beam , so If the bumper can be pulled forward at the top like you did rather than pulling the whole thing off plus allowing me to pull the sensor wires through ,using that gap it would be better for me , would you say it can be done ? All the other vids that cover the a4 b7 avant state you need to basically strip the whole boot out , i don't want to do that Cheers
@@jidislam3610thanks for replying, I wasn't going to loosen the bumper until I'd drilled the holes, i saw another guy drill with it on and it was fine, he did is without taking off or loosening the bumper and did it all from underneath, i figured after seeing your vid I'd prefer do it by pulling it forward like you did, although he did it the way he did it seemed like more hassle when it came to pulling the wires through Cheers