RESIN 3D PRINTING: Get started with Anycubic photon mono X 6kS! 

Enfin une video qui montre vraiment step by step chaque étape pour imprimer en 3D à la résine !! Un grand merci à toi ! Je viens d'acheter la même imprimante Anycubic photon mono X 6ks, je compte faire ma première impression résine ces jours ci, alors ta video est vraiment la bienvenue ! Un grand merci !! ;)

Vivement la prochaine vidéo qui parle de la consommation de cette machine et une bonne image de la qualité d'impression Histoire d'avoir une idée ce qu'elle a dans le ventre😂

Hello my French friend. Just some advice from experienced resin printer user. 1. replace that USB stick with a proper one (32Gb max). 2. Angle your prints properly. What you did is really wrong - creates a lot of suction and your print will be deformed, it can potentially even damage your FEP flooding your printer. Either rotate it to vertical position for something like that or angle it to roughly 45deg. Plenty of tutorials on youtube how to properly angle and support prints. 3. Possibly hollow it if you don't want to waste too much resin 4. Your vat cleaning procedure is very wrong. After printing check the print for any failures. If print was fine then really no need to clean after each print. If you spot something wrong with the print then use vat cleaning function (use some old leftovers of supports with raft, position in two corners, after cleaning procedure is complete just lift the whole lot). Don't use that spatula to lift the cured sheet, just use those supports. After removing the cured sheet use spatula (gently) or better silicone spatula to check for any bits that may have still be in the vat (normally there are none) but better safe than sorry. Finally - don't remove vat from the printer, there is no need. I barely ever do it. And no need to empty the vat and clean it after printing. I only do it if I want to use a different resin or I need to inspect FEP. 5. For cleaning vat use softer paper like tissues or ideally micro fibber cloth. Kitchen paper towels are hard and will scratch your FEP. 6. Don't use alcohol to clean vat, just soft tissue. Using IPA will fog the FEP. 7. You can put your print to hot water for a minute - it will soften the supports and removing them will be much easier and will leave less marks 8. Use gloves when you handle uncured prints. Uncured resin is really nasty. I would also recommend using goggles when you remove supports - this stuff can shoot across the room at speed of light, protect your eyes. 9. were trousers when you upload as public :)

Bonjour, l’imprimante fonctionne bien, pas de problème ? Merci alors dites quelque chose salut

Bonjour, une question : est-ce normal que l’imprimante d’un côté ait peu d’adhérence sur la première impression ?

So many things done wrong here