How is the sikaflex holding up on pvc? You can also try pulling silicon and cutting with a razor, then on metal you can use a wire wheel on a drill but you can't on frp
So far its still perfect. The only issue that is not really a problem is the exes sica that is exposed to the elements is sticky. I should have cleaned it better. But slowly it is being cleaned by sand and water etc. The joints are still super strong.
I wonder if you heat the blade up a little with a propane torch if the putty knife would cut through the Sikaflex easier. I don't know just a thought. But hey, Sikaflex is PVC based and the zodiac is made of PVC so it should work very well, I don't think you'll have any problems with it.
Heating the blade might be a good idea to bad i already removed all of it lol. I did not know sika was pvc based. Cool lets hope it works well then. Cheers
I've used other glues where the tube come away at rear letting water in and really not very strong. Would you use this product everywhere opposed to the 2 part stuff? Thanks