In this video we will make a roller stand.
Here is some useful information.
-The roller is 250mm long and 47mm in diameter.
-There are bearings at the ends 6203RS.
-The roller holder is made of angle 40x40x4mm length 300mm with two plates at the ends.
-The supporting square tube is 30x30x2mm.
-The central square tube is 35x35x2.5mm.
-It has a drilled hole for screw M10 and a welded nut M10 that is for tightening the roller bracket.
-Two plates welded to the central pillar 35x35x2,5mm bearing a sloping pillar 35x35x2,5mm
-The sloping column is fastened with an M10 screw and the angle can be adjusted on it.
-The legs are made of rectangular tubes 40x20x2mm.
-An M8 screw hole was drilled in the ends of the legs and M8 nuts were welded.
-With this part the height of the roller and the balance can be adjusted if the terrain is uneven.
Thanks for watching!!!
16 июл 2024