Rostock x301 Auto-Leveling 

This is a great update. I would like to know, which motherboard you use...The GTM32 has no connector for that. Can you explain something about your work, please?

Will you be sharing how you did this ? With all the problems this printer has and most people don't get a print out of it.

I've gone through most of your posts on thingiverse and got the new duet maestro board there, currently doing up the wiring. I was wondering how did you wire up the extruder cable? or did you just go straight to the pins and wire directly to the board?

hi i have the same 3d printer i can see that you change the motherboard, are you using a arduino mega with marlin?, You could explain how you did it? please I'm desperate I bought this printer almost 9 months ago and I can not print anything

Hey how u done. Plz reply. I have this 301 and i am bore of leveling plz rply

Hello, can do you send me the Firmware ?

How u do that

Some people just never learn how to film properly. Do it in landscape mode please!

Okay everyone, you can find information about this project on Thingiverse at www.thingiverse.com/thing:2389034