RSX Type-S RBC Intake Manifold Swap! 

You did a great job with the info on how to do it. I done it recently and man it was a hassle, but worth it for the top end. Great vid bro!

is that the oem throttle body? if it is what kind of cold air intake do you have and did it come with that same coupler… ive been trying to figure this out for a few days now. i got a skunk2 intake manifold and the throttle sits just like yours does. but now my old injen intake doesn’t fit

Where did you get those caps from? The one for the intake and coolant pipe etc.

The Method You Used To Take That Left Bolt Out Is Not Working For Me Any Other Ideas On How To Take Stud Out?

Nice video man, keep up the good work!

What throttle body adapter size is needed to install the rbc manifold ?

Do you have to tune the car after installation? I have a k24a rsx

I like this midnightclub 3 music lol

Just came across your channel. Just subscribed 💪

What kind of Cold Air Intake? specific model to fit the RBC? I know it’s injen just needed the same set up since RBC is too narrow. Thanks!

Hey why did you change your maf sensor position in the end?

Did you have to remove two screws from underneath the car support brackets?

Bro mine dont have the small lower left vaccum line close to the aternator should i just plug it??

Does the coolant needed to be drained out prior on doing this?

What if I’m using a 70mm throttle body? No adapter needed correct?

How did you get the coupler to make a straight fit with the injen and rbc? Mines is slightly canted which is robbing me ponies lol

Does make a big difference when ported.

Who did ur tune?

Are you In Az?

I don’t have to use the adapter if I have the ktuned rbc /Prb throtle body 70mm

This is not tedious, I had this done in the amount of time it takes my wife to do her hair

What coupler is that on the throttle body?

what did you use to block off the hole for the intake manifold? the small hole where the map sensor would go