Тёмный

Rugged Ranch Poultry Waterer Review 

thegreenworkbench
Подписаться 13 тыс.
Просмотров 2,4 тыс.
50% 1

I purchased a new tube style poultry waterer with a water cup and float to hopefully keep mice from getting into the chickens' water. It is made by Rugged Ranch. Here is a review of and link to the product.
amzn.to/2Y1OGH6
As an Amazon Associate I earn from qualifying purchases.

Хобби

Опубликовано:

 

28 ноя 2019

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 9   
@BigRedRockeater1930
@BigRedRockeater1930 2 года назад
I wish I would have watched your video before buying this product. I was frustrated at the install for the same reasons as you. They clearly didn't test this out with a focus group. It became a challenge but I once I abandoned their instructions. It will be anatomically impossible for many to get their hand all the way down to the bottom and have eough room for the fingers to tighten the nut. I was able to tighten the nut down without problem by holding the nut tight with two fingers while my wife screwed (tightened) the cup at the bottom. ~ Now ~ I hope this product works better for me than others.
@joshwehrman306
@joshwehrman306 11 месяцев назад
3 years later same problems. I had to have my kids start the nut then found it was too close to the edge to use a socket so i had to wedge it in place using a long flat screwdriver and spin the cup to tighten it. Also the directions were glued to the unside of the pipe at the bottom so i had to have my kids use a small round nose scraper to get the paper off so it didnt clog it later.
@misosoup127
@misosoup127 Год назад
Agree. Very frustrating, actually. The nut just isn’t catching. 2 minute job now 30 min plus.
@cindysilverstein8597
@cindysilverstein8597 Год назад
I had the same issue with the spout…I wish you Would have shown how you mounted the hanging bracket to the tube…there are little to no instructions on this and I am worried if I drill into the tube I will have a hole that leaks water!
@thegreenworkbench
@thegreenworkbench Год назад
You are supposed to drill through the tube with the screws to mount the hanging bracket. It shouldn't leak.
@skybox-101
@skybox-101 2 года назад
Won't drilling a hole into the tube cause it to leak?
@thegreenworkbench
@thegreenworkbench 2 года назад
For the hooks I used a little silicone on the screws. No leaking. The watering cup has a rubber washer.
@shanondavis6304
@shanondavis6304 3 года назад
I ordered 2 of these. Installed is ridiculous. One jammed open and lost all the water, the other jammed closed and wouldn't dispense water.
@thegreenworkbench
@thegreenworkbench 3 года назад
After a year I had to buy a different style of cup because the float valve went bad on this one. A great idea but overall still needs work.
Далее
ПОЮ НАРОДНЫЕ ПЕСНИ🪗
3:19:41
Просмотров 1,8 млн
В GEOMETRY DASH СДЕЛАЛИ GTA
00:27
Просмотров 380 тыс.
11 Ways To Accidentally Kill Your Chickens
11:53
Просмотров 691 тыс.
Poultry Water Cup Problems
5:02
Просмотров 168 тыс.
RentaCoop Chicken Waterer Review And Setup
6:13
Просмотров 4,5 тыс.
Chicken Waterer Heater Test
7:47
Просмотров 114
Купили новый бассейн 🔥
0:58
Просмотров 3 млн
Amazing
0:37
Просмотров 16 млн
Quantas vezes os ratinhos caíram?
0:18
Просмотров 31 млн