Тёмный

RX7's First Test Drive Had Me Worried - Clearing Out the Turbo Smoke 

RAD Potential
Подписаться 25 тыс.
Просмотров 4,1 тыс.
50% 1

Holy Coolant Air bubble. Didn't make it very far at all until these dang under drive pulleys tricked me into thinking I had the coolant bled off. Car is running well. A few small tweaks to be made, and verify no leaks, and we are good to go. It feels amazing to drive a stock rx7!
Join us on Patreon!
/ radpotential

Опубликовано:

 

30 сен 2024

Поделиться:

Ссылка:

Скачать:

Готовим ссылку...

Добавить в:

Мой плейлист
Посмотреть позже
Комментарии : 28   
@SerYil1
@SerYil1 2 года назад
remember to close the door by the frame, but nevermind the seatbelt :)
@caboose22320
@caboose22320 2 года назад
needs a seat belt
@mikescustomsrx7s671
@mikescustomsrx7s671 2 года назад
Firsttttt
@cptebi
@cptebi 2 года назад
god i need one of these
@washushe
@washushe 2 года назад
I have an video idea i personally would love to see: how to treat 12A 13B rotary to make sure its stays health for as long as possible? No porting just stock engines... There are so many diffrent opinions its hard to get the exact idea whats best for those engines. Is mineral 2T good for premix in 12A?
@chaileeportraits
@chaileeportraits 2 года назад
Im thinking about need for speed underground i don't know why and also ain't nobody talking about why he ain't putting on his seatbelt
@RADPotential
@RADPotential 2 года назад
Yea, I didn't realize until I had edited it. Really was focused on making sure the car wasnt coming apart haha. But yes, it needs to be a higher priority
@imaluigi9708
@imaluigi9708 2 года назад
Depending on how many mile it has on it, apex seals start to need replacement after a while.
@knivsu
@knivsu 2 года назад
Whats the ecu and exhaust setup on this car? Sounds nice but I know you can't swap midpipe and downpipe without tuning.
@RADPotential
@RADPotential 2 года назад
Stock ecu, racing beat exhaust. Has a catless down pipe and straight midpipe.
@jo-qp7mz
@jo-qp7mz 2 года назад
Yes! Go support AMC ! Ape Nation holding AMC stock strong
@bruhhh13
@bruhhh13 2 года назад
Is it cool in US to not wear a seatbelt? Whats with that..
@andrewnavagonzalez3724
@andrewnavagonzalez3724 2 года назад
Love these videos thank you so much
@psychicer5022
@psychicer5022 2 года назад
One time i drained coolant from the block, filled up the radiator and then test drove and the needle went uuup. And i hear all the air steam coming out. I didnt get very far tho I forgot to fill the block😅
@rotaryperfection
@rotaryperfection 2 года назад
Water pump flow to push that thermostat open??? Lol! Negative ghost rider. It's not the water force/pressure that opens the thermostat. Thermostats open due to the rated heat on the springs. The springs simply retract based on its rated temp and pulls the hat down. If there is no water on the spring, the thermostat cant open unless the air gets really hot.
@RADPotential
@RADPotential 2 года назад
Yea I understand the spring. But the fact that barely any water is moving, isn't going to help the thermostat open. Especially if there is any air in the system.
@rotaryperfection
@rotaryperfection 2 года назад
​​​@@RADPotential Yep definitely sounds laggy. You should be getting 10psi on the primary turbo at 2,300-2,400rpm. A properly running twin set up is VERY torquey down low. You may need to test each and every solenoid on the rats nest plus the manual operation of all the check valves and actuators if the owner approves that diag.
@RADPotential
@RADPotential 2 года назад
Yea, I am thinking that it will be fine like it is for what he wants to use it for. If he wants to start pushing more boost at low RPM, it may be beneficial to switch to a PFC at the same time. The car isn't really a "hot rod" for him
@RADPotential
@RADPotential 2 года назад
Your comment above has me thinking about how I can make a test waterpump and monitor pressures to see the effect if any on a thermostats effective opening time
@rotaryperfection
@rotaryperfection 2 года назад
@@RADPotential But if he has properly operating simplified sequential running 10psi, then you don't need an aftermarket ecu. There's this old saying about the 3 mod rule on FD's. Well that's actually false as long as you can keep the main boost at 10psi. Full exhaust and no cat is what REALLY causes major boost spikes. Boost spikes is how you kill a stock car. Can't believe he doesn't have a boost gauge with those current mods. That was the 1st thing I put on my FD as when I bought mine back in 2003. His car isn't running correctly regardless how he drives it but if he wants to get the primary turbo online, the factory ecu will handel it no problem. Pattern should be 10-8-10. If its spiking above 10psi even as it sits, then its dangerous regardless how soon the primary kicks in. Owner doesn't understand the performance he's loosing but I get it.
@ScottJ175
@ScottJ175 2 года назад
You almost forgot and grabbed that door card. You were reminding yourself as much as us weren't you?
@RADPotential
@RADPotential 2 года назад
Haha I did!! Had to roll the window down first lol!!
@Landmast0rz
@Landmast0rz 2 года назад
Thought the first bang was something breaking, but it was a backfire I'm guessing
@RADPotential
@RADPotential 2 года назад
Backfire. If you get a good quick shift they will do that. My rx8 does it as well
@ScottJ175
@ScottJ175 2 года назад
@@RADPotential my bone stock 2009 will even make little backfire poofs sometimes. Amuses me because I'm not even trying to be a pops and bangs boi.
@matb1223
@matb1223 2 года назад
Good job
Далее
A Stock FD RX7 Is a Magical Driving Experience
19:06
Просмотров 11 тыс.
🦊🎀
00:16
Просмотров 415 тыс.
Hybrid Bridgeport RX8 Dyno Results are SURPRISING...
15:29
TUNING | How it Works
11:50
Просмотров 7 млн
Mazda RX7 FB Finally Starts!!! Smoke Show Inside
16:29
We Bought the Internet’s CHEAPEST Turbo
16:34
Просмотров 1,4 млн
SKIN EFFECT! Why Current Doesn’t Run Inside
13:12
Просмотров 295 тыс.