sailfish - How to put on a wetsuit? 

sailfish - How to put on a wetsuit?
In this article, we will go over the proper way to put on a wetsuit without damaging it. The main thing to avoid is putting your fingernails through the soft rubber on the outside. To start, undo the velcro and fold the wetsuit down so that the logo shows on the outside. Using a sock or plastic bag can also help your foot slide through the rubber more easily. Once the wetsuit is on, make sure it fits firmly in your crotch and armpits. Finally, zip up the wetsuit and close the flap, making sure it is low enough to avoid rubbing on your neck.
Key Takeaways
Use a sock or plastic bag to help your foot slide through the rubber more easily.
Make sure the wetsuit fits firmly in your crotch and armpits.
Close the flap low enough to avoid rubbing on your neck.
Preparation of Wetsuit
We know that putting on a wetsuit can be a bit tricky, especially if you don't want to damage it. That's why we're here to help you prepare your wetsuit the right way, so you can enjoy your swim without any hassle.
First, undo the velcro of your wetsuit and fold it down so that the logo shows on the outside. This will make it easier to put on. You can also use a sock or a plastic bag to help your foot slide through the wetsuit more easily.
Next, grab the wetsuit from the inside and roll it down. It can be a bit challenging to put on, especially if it's warm outside. Once you get it on, make sure it's pulled up firmly into your crotch. You want a snug fit, but not too tight.
Now it's time to put on the arms. Use a plastic bag to help slide through the rubber and fold it inside out a little bit to make it easier. Extend the left arm and pull it up into your armpit. You don't want a lot of loose space in there. Repeat the same process with the right arm.
Finally, zip up the wetsuit. This is always easier if you have a friend to help you. When closing the flap on the wetsuit, make sure to close it low, so it doesn't rub on your neck. You want it to make a nice bind with the velcro.
That's it! Now you're ready to go for a swim. Remember to make sure the wetsuit is pulled up firmly into your crotch and armpits. This will help you get the most out of your swim without any discomfort.
Inserting the Legs
When putting on a wetsuit, it is important to avoid damaging the soft rubber on the outside. To insert the legs, we recommend using a sock or a plastic bag to help your foot slide through the wetsuit more easily.
First, undo the velcro on the wetsuit and fold it down so that the logo is on the outside. Then, grab the wetsuit from the inside and roll it down. This can be difficult, especially if it's warm outside. Once you have the wetsuit on, pull it up and adjust the seams so that they are roughly underneath your knees.
Next, use a plastic bag to slide your foot through the rubber. Fold the bag inside out to make it easier. Pull the wetsuit up into your crotch, making sure it fits firmly. Repeat the same process for the other leg.
It's important to ensure that there is no loose space in your crotch or armpits. This will help keep the wetsuit snug and prevent water from entering. Once you have inserted both legs, zip up the wetsuit. It's easier to do this with the help of a friend.
When closing the flap on the wetsuit, make sure to close it low on the suit. This will prevent it from rubbing on your neck. Ensure that the velcro is firmly bound and you're ready to hit the water!
By following these simple steps, you can put on your wetsuit with ease and avoid damaging the soft rubber on the outside.